Leica CTR35 User Manual Version 1.
Introduction Purchase Congratulations on the purchase of a Leica CTR35. This manual contains important safety directions as well as instructions for setting up the product and operating it. Refer to "1 Safety Directions" for further information. Read carefully through the User Manual before you switch on the product. Product Identification The model and serial number of your product are indicated on the type plate.
Table of Contents In this manual Chapter Page 1 Safety Directions 2 1.1 General Introduction 1.2 Definition of Use 1.3 Limits of Use 1.4 Responsibilities 1.5 Hazards of Use 1.6 Electromagnetic Compatibility EMC 1.7 FCC Statement, Applicable in U.S. 1.8 IC Statement, Applicable in Canada. Description of the System 3 Operation 4 Configuration 10 5 Troubleshooting 13 6 Care and Transport 6.1 Transport 6.2 Storage 6.3 Cleaning and Drying 14 14 14 14 7 Technical Data 7.
1 Safety Directions 1.1 General Introduction Description The following directions enable the person responsible for the product, and the person who actually uses the equipment, to anticipate and avoid operational hazards. The person responsible for the product must ensure that all users understand these directions and adhere to them. 1.2 Definition of Use Intended use • Remote control of product. • Data communication with external appliances.
1.4 Responsibilities Manufacturer of the product Leica Geosystems AG, CH-9435 Heerbrugg, hereinafter referred to as Leica Geosystems, is responsible for supplying the product, including the user manual and original accessories, in a safe condition. Person responsible for the product The person responsible for the product has the following duties: • To understand the safety instructions on the product and the instructions in the user manual.
1.6 Electromagnetic Compatibility EMC Description The term Electromagnetic Compatibility is taken to mean the capability of the product to function smoothly in an environment where electromagnetic radiation and electrostatic discharges are present, and without causing electromagnetic disturbances to other equipment. WARNING Electromagnetic radiation can cause disturbances in other equipment.
1.7 FCC Statement, Applicable in U.S. WARNING Changes or modifications not expressly approved by Leica Geosystems for compliance could void the user's authority to operate the equipment. WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
2 Description of the System General Technology The CTR35 is a radio device having a long-range radio module. It can be used on Leica CS35 tablets only to extend the radio range. The CTR35 is intended to be connected to the following radio devices: • RH16/RH17 • TCPS29/TCPS30 Frequency The CTR35 operates in the "2.4 GHz radio band". Using the latest in spread-spectrum, frequency hopping technology, ensures maximum security for the high speed, wireless transfer of data and video.
3 Operation Standard setup with CTR35 on CS35 Standard setup at the CS35 for remote surveying using the CTR35. The CTR35 can be connected to the following radio devices: • RH16/RH17 • TCPS29/TCPS30 These radio devices can be attached to the following instruments: • MS60/TS60/TS16 • MS50/TS50/TM50/TS15 • TS30/TM30/TPS1200+ 012075_001 Pairing of the CTR35 CTR35, Operation The pairing is done from the CS35 with the steps described in the following chapter, refer to Configuration.
4 Configuration Requirements for the correct configuration of the CS35 • Leica Captivate version 2.0 or higher • The configuration process as described below only needs to be done once. Mount the CTR35 to the CS35 The CTR35 has to be mounted to the CS35 as follows for a robust fixing: Step Description 1. Open the door of the top USB port on the CS35 completely. 2. Hold down the opened door of the CS35. 3. Insert the CTR35 with the USB plug into the top USB port of the CS35 as far as possible.
Install the driver of the CTR35 on the CS35 Step Description 1. Download the CTR35 driver from myWorld. It is found in the folder Controller\CS35\Tools. 2. Mount the CTR35 to the top USB port of the CS35, refer to Mount the CTR35 to the CS35. Set the COM Port on the CS35 CTR35, Configuration 3. Open the Start screen. 4. Tap the Control Panel tile. 5. Choose Device Manager. 6. Open Other devices from the tree view. 7. Tap and hold onto CTR35. 8. Choose Update Driver Software...
Run the executable file on the CS35 Step Description 1. Download the executable file CTR35NetConnInstaller.exe from myWorld. It is found in the folder Controller\CS35\Tools. 2. Run the executable file CTR35NetConnInstaller.exe either from a USB stick or from the CS35. The net configurations are installed. 3. Configure the CTR35 with Leica Captivate on the CS35 CTR35, Configuration Close all applications. A wizard guides through the Leica Captivate connection settings.
5 Troubleshooting Troubleshooting Problem Troubleshooting CTR35 is not powered. • Check, if CTR35 is properly connected to the correct USB port of the CS35. • Check status of the LED. Refer to Description of the LED indicator. Leica Captivate error message: "Attach CTR35 LRBT stick" (but CTR35 is powered). • Check driver installation and COM port setting. Refer to Install the driver of the CTR35 on the CS35 and Set the COM Port on the CS35.
6 Care and Transport 6.1 Transport Transport in a road vehicle Never carry the product loose in a road vehicle, as it can be affected by shock and vibration. Always carry the product in its transport container, original packaging or equivalent and secure it. Shipping When transporting the product by rail, air or sea, always use the complete original Leica Geosystems packaging, transport container and cardboard box, or its equivalent, to protect against shock and vibration. 6.
7 Technical Data 7.1 CTR35 Technical Data Dimensions (with cover) Length [mm] Width [mm] Thickness [mm] 81.65 21.40 17.06 Length [in] Width [in] Thickness [in] 3.21 0.84 0.67 Weight Power Weight [g] Weight [oz] 18 0.63 Power supply Power consumption By USB 2.0 Interface: Nominal voltage 5.0 V DC ( Voltage range 4.75–5.
7.2 Conformity to National Regulations Conformity to national regulations • FCC Part 15 (applicable in US) • Hereby, Leica Geosystems AG, declares that the product CTR35 are in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC and other applicable European Directives. The declaration of conformity can be consulted at http://www.leica-geosystems.com/ce.
CTR35, Technical Data 17
843695-1.0.0en Original text Printed in Switzerland © 2016 Leica Geosystems AG, Heerbrugg, Switzerland Leica Geosystems AG Heinrich-Wild-Strasse CH-9435 Heerbrugg Switzerland Phone +41 71 727 31 31 www.leica-geosystems.
CTR35, Technical Data 19
CTR35, Technical Data 20
CTR35, Technical Data 21