Wireless Room Scene Remote Specifications Power Supply ................ Two AAA Alkaline Batteries, provided Operating Temperature.................
UNIT DESCRIPTION The adorne ADMHRM4 Wireless Room Scene Remote is a room level scene controller. It provides instant recall of four user-recorded lighting scenes (or presets) assigned to a room or designated area. It also provides off and on functions, overall control of the room’s light level, all with convenient, handheld portability. It is used to control a variety of adorne wireless devices including dimmers, switches, plug-in appliance modules and plug-in lamp modules.
SET HOUSE ID All adorne wireless devices installed in the same home must acquire the same unique House ID before use. This process is known as house binding. Each adorne wireless device is bound to all other adorne wireless devices in the house. New Installation 1. With all devices installed and energized, make sure that every A adorne wireless device LED is B orange. If any LED is off, be sure C D the circuit breaker is on and the E device is correctly installed.
ROOM BINDING After the House ID is set in the remote, you create a room by binding devices to the remote. You can also add the ADMHRM4 to an existing room. When a new ADMHRM4 is added to a room, its scene buttons execute the same scenes as other room scene controllers with the same scene set assignment (see MORE SCENES). Paddle functions are the same at every room scene remote and controller that is bound to the same room, regardless of scene set assignment.
STANDARD OPERATION The ADMHRM4 is shipped with most functions preprogrammed for ease of installation and initial use. This section summarizes the default operation of the remote. To make changes from this standard operation, such as changing light levels and including or excluding devices from specific scenes, see CUSTOMIZING OPERATION. Paddle Functions Use the rocker paddle to begin and end binding functions. It also functions as an On/Off switch and a master light level Raise/Lower control for the room.
A B C D E When you see in the instructions, touch the top of the paddle as directed. CUSTOMIZING OPERATION ROOM REMOTE 4 FINGERS A B C D E When you see in the instructions, touch the bottom of the paddle as directed. ROOM REMOTE 4 FINGERS Modify and Save the Light Levels of a Scene 1. Change lighting levels as desired by pressing or on individual devices. 2. Press and hold the desired scene button on the room scene remote until the LED flashes twice (about 5 seconds ) to save the new settings.
1. Press on the ADMHRM4 until the LED begins flashing (about 5 seconds ). 2. Tap the paddle on the remote. The LEDs on all the adorne wireless devices begin to flash. You now have 5 minutes to complete this process. 3. See step 3 above. 4. See step 4 above. 5. To test, tap on any room scene controller that is bound to the same room to switch or fade included devices to off (dimmers go to 0%) BATTERY INFORMATION The ADMHRM4 operates using two 1.5V Alkaline AAA size batteries.
FCC Notice - FCC ID: YV8-ADMHRM4 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications to this device not explicitly approved by Legrand could void your authority to operate this equipment.