GUIDE SPECIFICATIONS This guide specification is written according to the Construction Specifications Institute (CSI) formats, including MasterFormat, SectionFormat, and PageFormat. Carefully review and edit this section to meet the requirements of the project and local building code. Coordinate this section with other specification sections and drawings. Delete all "Specifier Notes" when done editing this section. SECTION 16140 WIRING DEVICES PART 1 - GENERAL 1.1 A. 1.
GUIDE SPECIFICATIONS 1. 2. 3. B. Underwriters Laboratories Inc. (UL): 1. 2. 3. 4. 1.5 CSA C22.2 No. 42-2010 (R2015) - General Use Receptacles, Attachment Plugs, and Similar Wiring Devices. CSA C22.2 No. 111-2010 (R2015) - General-Use Snap Switches. CSA C22.2 No. 223-2015 - Power Supplies With Extra-Low Voltage Class 2 Outputs. UL 20 - Standard for General-Use Snap Switches. UL 498 - Standard for Attachment Plugs and Receptacles. UL 514D - Standard for Cover Plates for Flush-Mounting Devices.
GUIDE SPECIFICATIONS B. 2.2 Substitutions will be considered under provisions of Section 01635. STRAIGHT BLADE DUPLEX RECEPTACLES Specifier Note: Retain as many of the following products as required for a specific project and delete the others. A. Straight Blade Duplex Receptacles: 1. General: Receptacles comply with UL 498 and CSA C22.2 No. 42. Specifier Note: Retain one color and delete the others in brackets after Part No. and from description. 2. Duplex Receptacles: radiant® Part No.
GUIDE SPECIFICATIONS resistant thermoplastic construction; automatic ground clip; extra-long mounting strap; Quickloop wire looping aid; tri-drive screws; side-access push wire release; side wire accepts #12 - #14 AWG solid, push wire accepts #14 AWG solid only; [light almond] [ivory] [white] [brown] color. E. 20A Straight Blade Tamper-Resistant Duplex Receptacles: 1. General: Receptacles comply with UL 498 and CSA C22.2 No. 42. Meets NEC® Tamper-Resistant requirements. UL listed; CSA compliant.
GUIDE SPECIFICATIONS three seconds to insure that ground fault protection is active; auto-ground clip; audible alarm; [light almond] [ivory] [white] [brown] [black] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 5. 15A Specification Grade Self-Test Combination Tamper-Resistant Switch/GFCI Duplex Receptacles (No Federal Specification): Part No.
GUIDE SPECIFICATIONS terminals accept #14 - #10 AWG solid or stranded copper or copper-clad conductors; SafeLock® Protection performs an automatic test every three seconds to insure that ground fault protection is active; auto-ground clip; indicator light; [light almond] [ivory] [white] [brown] [black] [gray] [red] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 10.
GUIDE SPECIFICATIONS terminals accept #14 - #10 AWG solid or stranded copper or copper-clad conductors; SafeLock® Protection performs an automatic test every three seconds to insure that ground fault protection is active; auto-ground clip; indicator light; [light almond] [ivory] [white] [brown] [black] [gray] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 15.
GUIDE SPECIFICATIONS test/reset buttons; thermoplastic tamper-resistant shutter; terminals accept #14 #10 AWG solid or stranded copper or copper-clad conductors; SafeLock® Protection performs an automatic test every three seconds to insure that ground fault protection is active; auto-ground clip; indicator light; [light almond] [ivory] [white] [brown] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 20.
GUIDE SPECIFICATIONS an automatic test every three seconds to insure that ground fault protection is active; indicator light; auto-ground clip; [light almond] [ivory] [white] [brown] [black] [gray] [red] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 5. 20A PlugTail® Specification Grade Self-Test Tamper-Resistant GFCI Duplex Receptacles: Part No.
GUIDE SPECIFICATIONS 10. 20 amps, 125 volts; nylon face, body, and test/reset buttons; thermoplastic tamper-resistant shutter; PlugTail® right angle connector with six (6) inch #12 AWG THHN stripped, solid or stranded, copper leads; SafeLock ® Protection performs an automatic test every three seconds to insure that ground fault protection is active; auto-ground clip; [light almond] [ivory] [white] color. RoHS Compliant.
GUIDE SPECIFICATIONS face, body, and test/reset buttons; thermoplastic tamper-resistant shutter; terminals accept #14 - #10 AWG solid or stranded copper or copper-clad conductors; SafeLock® Protection performs an automatic test every three seconds to insure that ground fault protection is active; auto-ground clip; indicator light; [light almond] [ivory] [white] [brown] [black] [gray] [red] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No.
GUIDE SPECIFICATIONS copper-clad conductors; SafeLock® Protection performs an automatic test every three seconds to insure that ground fault protection is active; auto-ground clip; indicator light; [light almond] [ivory] [white] [gray] [red] [orange] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 8. 15A Hospital Grade Self-Test Combination Tamper-Resistant Night Light/GFCI Duplex Receptacles: Part No.
GUIDE SPECIFICATIONS terminals accept #14 - #10 AWG solid or stranded copper or copper-clad conductors; SafeLock® Protection performs an automatic test every three seconds to insure that ground fault protection is active; auto-ground clip; [light almond] [ivory] [white] [red] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 13. 20A NAFTA-Compliant Hospital Grade Self-Test GFCI Duplex Receptacles: Part No.
GUIDE SPECIFICATIONS resistant shutter; PlugTail® right angle connector with six (6) inch #12 AWG THHN stripped, solid or stranded, copper leads; SafeLock® Protection performs an automatic test every three seconds to insure that ground fault protection is active; indicator light; auto-ground clip; [light almond] [ivory] [white] [black] [gray] [red] color. RoHS Compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 18.
GUIDE SPECIFICATIONS rated 20 amps, 125 volts; nylon face, body, and test/reset buttons; thermoplastic tamper-resistant shutter; PlugTail® right angle connector with six (6) inch #12 AWG THHN stripped, solid or stranded, copper leads; SafeLock ® Protection performs an automatic test every three seconds to insure that ground fault protection is active; auto-ground clip; indicator light; Lexan® nightlight lens; ivory color. RoHS Compliant. 2.
GUIDE SPECIFICATIONS 2. Two Single Pole Paddle Switches: radiant® Part No.
GUIDE SPECIFICATIONS a. D. Snap-In Light Module: radiant® Part No. RCDLM locator light module snaps-in for easy installation; rated 15 amps, 120/125 VAC; lights when OFF; uses energy-efficient LED light; LED light will not generate heat and will last, on average, 47 years. Single Pole/3-Way Paddle Switch and 15A Tamper-Resistant Outlet: 1. General: Switches comply with UL 20 and UL 498. Devices are cULus listed. Specifier Note: Retain one or more colors and delete the others in brackets after Part No.
GUIDE SPECIFICATIONS 2. 3. 4. 5. 6. 7. 8. 9. Project Name Project Location 15A Single-Pole Switches: radiant® Part No. TM870[LA][I][W][-][BK][GRY][NICC10][DBCC10]; single-pole switch rated 15A, 120/277 VAC; designer-style, satin-finish rocker switch; high-impact resistant thermoplastic construction; narrow back body; extra-long, through-body strap; [light almond] [ivory] [white] [brown] [black] [gray] [nickel] [dark bronze] finish and color; UL listed and CSA compliant.
GUIDE SPECIFICATIONS 10. 11. 2.8 wired accepts #12 and #14 AWG stranded and copper wire; push wiring for #14 AWG stranded and copper; narrow back body; extra-long, through-body strap; easy-access green hex head ground screw; Tri-drive ground, terminal, and mounting screws; ON/OFF switches conform to NEC 430-104 requirements for kitchen and disposal units; [light almond] [ivory] [white] [brown] [black] [nickel] [dark bronze] finish and color; UL listed and CSA compliant.
GUIDE SPECIFICATIONS (not compatible with 0-10V LED drivers), EFL: 5.5A; polycarbonate Lexan® construction; tri-color: [light almond] [ivory] [white]; [white] only. C. Single Pole/3-Way LED/CFL/Incandescent Dimmers: 1. General: Comply with UL 1472; cULus listed and CSA compliant. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 2. Single Pole/3-Way LED/CFL/Incandescent Dimmers: radiant® Part No.
GUIDE SPECIFICATIONS white LED locator light; polycarbonate Lexan® construction; tri-color: [light almond] [ivory] [white]; [white] only; Specifier Note: The following additional colors are available and sold separately. Retain one or more colors and delete the others in brackets as required. a. G. Face Colors: radiant® Part No. RHKIT[LA][I][W][BK][GRY][NI][DB]; [light almond] [ivory] [white] [black] [gray] [nickel] [dark bronze] finish and color.
GUIDE SPECIFICATIONS or fins to break; white LED locator light; polycarbonate Lexan® construction; tricolor: [light almond] [ivory] [white]; [white] only. Specifier Note: The following additional colors are available and sold separately. Retain one or more colors and delete the others in brackets as required. a. J. Face Colors: radiant® Part No. RHKIT[LA][I][W][BK][GRY][NI][DB]; [light almond] [ivory] [white] [black] [gray] [nickel] [dark bronze] finish and color.
GUIDE SPECIFICATIONS 2.11 NIGHT LIGHTS Specifier Note: Retain as many of the following products as required for a specific project and delete the others. A. Night Light Devices: 1. General: Devices comply with NEMA WD-1 and WD-6. Devices are cULus listed. Specifier Note: Retain one or more colors and delete the others in brackets after Part No. and from description. 2. Night Lights with Two 15A Tamper-Resistant Receptacles and Adjustable Light Levels: radiant® Part No.
GUIDE SPECIFICATIONS a. 2.13 A. Face Colors: radiant® Part No. RHKIT[LA][I][W][BK][GRY][NI][DB]; [light almond] [ivory] [white] [black] [gray] [nickel] [dark bronze] finish and color. SCREWLESS WALL PLATES General: Single and combination types matching corresponding wiring devices. Specifier Note: Screwless wall plates are available in one (1) through six (6) gang sizes to complement radiant™ switches, sensors, and receptacles. B. Wall Plates: Molded of .065" thick polycarbonate with .
GUIDE SPECIFICATIONS 3.2 INSTALLATION A. Strictly comply with manufacturer's installation instructions and recommendations. Coordinate installation with adjacent work to ensure proper clearances and to prevent electrical hazards. B. Repair wall finishes and remount outlet boxes when device plates do not fit flush or do not cover rough wall opening. 3.3 CLEANING AND PROTECTION A. Clean exposed surfaces using non-abrasive materials and methods recommended by manufacturer. B.