Installation Instructions
x1
2 AA batteries
2 x AA - 1,5 V
+ 5° C / + 45° C
PIR
2 - 8 m
5 - 1000 LUX
de 15 s - 15 min
IP 44
Pack contents
Wireless motion sensor
This product is a connected accessory which requires you to buy and install one of these rst:
- … with Netatmo" connected starter pack and "… with Netatmo " connected power outlets,
switches (with dimmer option).
- Connected lighting micromodules.
- Radiant with Netatmo Gateway and radiant with Netatmo Switch, Dimmer or Receptacle.
- Adorne with Netatmo Gateway and adorne with Netatmo Switch Dimmer or Receptacle.
Specications
This product can control up to 20
connected switches (with dimmer option),
micromodules, cable outlets and power
outlets «... with Netatmo»
Frequency bands: 2.4 - 2.4835 GHz
Power level : < 10 mW
Wireless motion sensor
0 648 75
LE11418AB
Do not insert the batteries now
Start the wireless motion sensor conguration
Press the middle of the wireless master switch
until its light briey turns green, and then
stop pressing. The indicator lights on the
products which you have wired will turn green.
Press the Gateway EZ button for 5 seconds
and let go. The LED will turn solid green or
follow the app to add device.
Open the front cover
2
restart on Step 2
Insert the batteries in the wireless motion sensor
A
B
C
D
C
Make sure that the indicator lights on the wired products are green and not
Pair the wireless motion sensor to a wired connected product
To pair a wireless motion sensor with a connected light switch, go to step 4.1.1
To pair a wireless motion sensor with a connected micromodule, go to step 4.2.1
To pair a wireless motion sensor with a connected power outlet, go to step 4.3.1
Step A : Press the ON button on the wireless motion sensor you wish to pair, while tapping
it three times onto the light switch you wish to control.
Step B : The indicator lights on the two products will ash blue rapidly.
Step C : The indicator lights on the two products will briey turn blue and stop ashing.
Step D : the light on the wired product will turn green again and the light on the wireless
motion sensor will switch o. The pairing was successful.
43
4.1.1 Pair a wireless motion sensor with a connected light switch
CLICK
Note
come back to step 4.
A
B
C
A
B
D
D