Module Certification Type Certification Information FCC LA02302 IC Symbol Parameter Min. Max. Units VCC Power Supply -0.3 +3.6 V GND Ground of Module 0 V VIO Voltage of Module IO +3.6 V -0.
Storage temperature 2. -40 +125 Deg-C MSL Moisture Sensitivity Level 3 ESD HBM Human Body Mode 1.5 KV ESD CDM Charge Device Mode 500 V Symbol Parameter Min. Typ. Max. Units VCC Supply voltage, normal 3.0 3.3 3.6 V TA Operation temperature 1 -40 25 105 Deg-C ICC peak Supply Current Peak2 - 400 450 mA ICC average Supply Current average 2 - 150 mA It is measured when the module runs the RF test Firmware @ 10% duty cycle and 25 Deg-C ambient temperature.
ITX 802.11g average Transmit 11g OFDM 54Mbps Pout=+13 dBm - 130 - mA ITX 802.11n peak Transmit 11n OFDM MCS0 Pout=+17.5 dBm - 328 - mA ITX 802.11n average Transmit 11n OFDM MCS0 Pout=+17.5 dBm - 140 - mA ITX 802.11n peak Transmit 11n OFDM MCS7 Pout=+12 dBm - 256 - mA ITX 802.
Receiver sensitivity @11n OFDM HT40 MCS7 - -68 - dBm Maximum receiving level @11n OFDM HT40 MCS7 - -8 - dBm Symbol Description Min. Typ. Max.
10 49 GND ground of module -- 11 40_U0RXD RX0 FACTORY_UART_ RX data in (RX) I 12 41_U0TXD TX0 FACTORY_UART_TX data out (TX) O 13 10_VDET_1 FACTORY_MODE_ N FACTORY MODE enable, low active I 14 23_GPIO0 SLEN BM_SEL for UART boot; Default: weak pull up I/O Note: 1. AC_TRIAC_DETECT is used to detect if a device is powered through a triac dimmer and to determine the dimmer settings.
Min. Typ. Max. Min. Typ. Max. Set points( ) Zone 1 2 3 4 5 6 7 8 9 10 Top 140 180 190 180 180 190 245 260 265 210 Bottom 140 180 190 180 180 190 245 260 265 210 Conveyor Speed cm/min 130.
st autorisée aux deux conditions suivantes :