Quick Start Guide

ManualsBrandsLEEDARSON ManualsElectronicsDoor Window by pass Sensor

Arize Entry sensor-AES220

Content:

Door Window by pass Sensor ............................................................................................................................ 2

Quick Start Guide............................................................................................................................................ 2

1. Product Introduction ............................................................................................................................ 2

2. Product Installation .............................................................................................................................. 3

3. Safety Information ............................................................................................................................... 3

4. Maintenance ........................................................................................................................................ 4

5. FCC compliance notice ......................................................................................................................... 4

Summary of content (5 pages)

PAGE 1
Arize Entry sensor-AES220 Content: Door Window by pass Sensor ............................................................................................................................ 2 Quick Start Guide............................................................................................................................................ 2 1. 2. 3. 4. 5. Product Introduction ............................................................................................................................
PAGE 2
Door Window by pass Sensor Quick Start Guide 1. Product Introduction The Arize door window sensor is designed for use with scenes in home automation and security systems, the door window sensor lets you know when door or windows is opened and can trigger different actions in response to that open action (or close action). Specification Detection Technology Hall Detection Range 20mm Communication Protocol Zigbee Protocol Zigbee 3.
PAGE 3
Bypass switch YES Certifications CE/FCC 2. Product Installation This product can be mounted by screws or 3M adhesive tape, install it according to the following step: ① Remove the plastic sheet for isolating battery from battery cabinet. ② Use a pin to reset the pinhole switch for 3 seconds to reset the sensor. The sensor will be in pairing status. This will cause a LED indicator to flash once per second. If sensor enrolled successfully, it will stop blinking and stay on for 10 seconds.
PAGE 4
. Maintenance ① How to reset a door/window sensor? Keep pressing the reset key about 3 seconds, then the LED indicator will start blinking quickly. Once release the key, the sensor will reset to factory setting and the LED indicator blinks once per second to search a new enabled Zigbee network. ② How to join a door/window sensor? After the sensor is reset to the factory setting, the signal light blinks once per second and sensor starts searching an enabled Zigbee network.
PAGE 5
FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 7 FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.