Leedarson Zigbee LED Bulb Quick User Guide Draft Ver. V V1.0 Description Time 2019.2 THANK YOU We appreciate the trust and confidence you have placed in LEEDARSON through the purchase of Zigbee Light Bulb. We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Product Introduction 1.1 Basic Information CONTROL YOUR LIGHTS FROM ANYWHERE in the world from the palm of your hand. The Retrofit produces beautiful high quality light that you can dim or tune, and control from your smartphone or tablet. Easy to setup, bulbs fit into your standard household sockets - no need for installation by an electrician. A wireless network or remote controller is required to operate bulbs.
a compatible wireless switch that uses the same wireless protocol as the bulb. 1.3 Leave your fixture on If your switch or fixture is OFF,or is turned OFF, then control and communication from the App, or wireless switch, to the LED Bulb is lost. Inclusion Procedure The following are the general procedures for the Zigbee bulb to be “included” into the network: 1. Screw the bulb into a standard socket. 2. Turn on the bulb with your wall switch to apply power to the bulb.
Warning 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications or changes could void the user’s authority to operate the equipment.
between the radiator and your body. IC Statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.
3) Not suitable for use with standard wall dimmers 4) 5) 6) 7) 8) 9) Suitable for use in operation environment between -4℉ and 104℉(-20℃ and 40℃) Not for use in emergency lighting. The bulb is not suitable for totally enclosed fixtures. Do not clean the bulb when it is on and connected to the power supply Do not place the bulb on hot surfaces Dispose of this device in accordance with disposal laws in your area.