We build your success in IoT.
Zigbee Motion Sensor Pet immunity Quick Start Guide 1. Product Introduction The Motion Sensor lets you know when movement is detected in a certain area and can trigger different actions in response to that movement (or lack of movement). It supports the pet immunity up to 80 lbs. This sensor integrated Zigbee communication module to connect with Zigbee gateway, and this device can be adapted to 2.4G Zigbee gateway.
Reset button Bracket ① Reset : Press the reset button for 3 seconds then release the pin to reset the sensor. After the reset, the sensor will be found by the App or the gateway when they search for the device. ② LED Indicator: If sensor has not been added to gateway, the LED will be blinking about one time per second. The LED will turn off when joined to gateway successfully. ③ Anti-Tamper switch: gateway..
Specification Detection angle 80 degrees Detection distance 8 meters / 26.25 feet Pet immune 80 lbs (36 kgs) Mounting height 6.23 ft. to 7.55 ft. (1.9m to 2.3m) Light sensor 20 lux for day/night(bright/dark) Protocol Zigbee 2.
3. Features/Capabilities: Supports pet immunity up to 80 lbs (36 kgs) Use PIR & Fresnel lens technology Easy installation with bracket Low battery alarm Equipped with an anti-tamper switch that reports any tampering 4. Installation Position and Notes 1. Installation position should be chosen at the area which the bass-by will be across, try to make the bassby in the detection area as below.
2. Do avoid installation near air-conditioner, electric fans, refrigerators, ovens or other places where temperature easy change. 3. In order not to affect the detecting result, there should be no object in front of the produces lens. 4. Building (such as the wall) will shorten the distance of wireless communication. 5. This device can be mounted on the wall only, it cannot be installed on the ceiling. 5.
5. The reference range template of PIR detection is tested at the indoor temperature (the range is 20℃~ 25℃),the target of the test is 77kg±10kg weight and 1.71m±0.3m height, the target of the test across movement speed is 4m/s±0.15m/s. 6.
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.