6Vy-A806ST-Q1Z Leedarson LED Bulb CCT Quick User Guide Draft Ver. Fu V1.0 Leedarson Lighting Description Time 2016.12.
1 Product Introduction 1.1 Basic Information CONTROL YOUR LIGHTS FROM ANYWHERE in the world from the palm of your hand. The CCT Retrofit produces beautiful high quality light that you can tune, dim, and control from your smartphone or tablet. Easy to setup, bulbs fit into your standard household sockets - no need for installation by an electrician. A wireless network is required to operate bulbs. SET LIGHT SCENES: Create rich indirect light scenes in your home by 2700-6500K white.
Inclusion Procedure The following are the general procedures for the Z-Wave bulb to be “included” into the network: 1. Screw the CCT bulb into a standard E27 socket. 2. Turn on the bulb with your wall switch to apply power to the bulb. a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb. 3. Activate the “inclusion”mode on your Z-wave controller or gateway. a) This may also be done through your associated app,if your ecosystem has that capability. 4.
1.5 Behaviors of the bulb This bulb has some behaviors to indicate users the status of the bulb. 1.5.1 Factory Reset mode The bulb will flash twice when it is powered on in reset mode or factory mode. 1.5.2 Inclusion Mode The A19 bulb will flash once when it has been included into the network. 1.5.3 Exclusion Mode The A19 bulb will flash once and then dim to 5% when it has been excluded outside the network.
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 3.
