Leedarson Arrival Sensor Quick User Guide Draft Ver. Fu V1.0 2016.10.10 V1.1 2017.06.
1 Product Introduction 1.1 Basic Information Arrival sensor integrated Z-Wave communication module to connect with Z-Wave gateway. By real-time communication to verify if the device in the communication range of gateway, system can automatically trigger some relative scenarios and send out messages to especial person. 1.2 System Diagram Scenarios Arrival Sensor Gateway Router MID* *MID: Mobile Internet Device 1.
Max. Power Consumption Standby Power About 120mW 22uA in Average 1.4.3 Battery Battery Type Charging Cycle 150mAh Li-Poly ≤45 days 1.4.4 Condition Storage environment: Operational temperature: -5-45℃, <90%, non-condensing 0-40℃ 2 Hardware Specification 2.1 Structure Dimensions: 43mm（H）*34mm（W）*16mm（D） Weight: 30g Material: PC 2.2 Functional Description 2.2.
mode. 2.2.3 LED Indicator LED indicator embedded in internal PCBA and support red/yellow colors to display different status of devices. Connecting Red indicator quickly flash for 3 times, if successfully connected, red indicator hold on for 3 seconds. Connected Red indicator keep on for 3s. Resetting Red indicator slowly flash for 2 times. Charging Blue indicator quickly flash until full charged. Low Power Blue indicator slowly flash, about 2 minutes once 2.3 Product Operation 2.3.
2.3.5 Connection Logic Caution: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Changes or modifications not expressly approved by the part responsible for compliance could void the user's authority to operate the equipment.
