User's Manual

ManualsBrandsLEEDARSON LIGHTING ManualsElectronicsGateway

Table Of Contents

GATEWAY BAF

 Support Zigbee Protocol, 2.4G, 802.15.4, low power consumption

 Communication range up to 40 meters (Line of sight)

 Connect nodes up to 32, just right for smart home application

 Plug and play by RJ45 Ethernet port , network connection is very easy and

reliable

 Internal buzzer makes different tone for reporting gateway status. It can

be set on/off by app to link with sensor for scenario and application.

 Styling design、simple、neat, power cable and Ethernet cable are

connected inside case.

 133(L)X100(W)X34.5(H)mm, Weight 108g

 indoor use only

 CE & FCC complied

Summary of content (4 pages)

PAGE 1
GATEWAY BAF          Support Zigbee Protocol, 2.4G, 802.15.4, low power consumption Communication range up to 40 meters (Line of sight) Connect nodes up to 32, just right for smart home application Plug and play by RJ45 Ethernet port , network connection is very easy and reliable Internal buzzer makes different tone for reporting gateway status. It can be set on/off by app to link with sensor for scenario and application.
PAGE 2
GATEWAY set up guide Step 1: Please open the gateway upper cover. Connect the power adapter cable to micro USB port. Connect the RJ45 cable from router to Gateway RJ45 port. Step 2: Turn on power of both router and gateway. Gateway will get connection to router upon receiving IP assignment from router automatically. Step 3: Press pair key(or start searching by app) to launch searching and connecting those un-pairing devices. Launch searching process before turn on ZLL bulbs.
PAGE 3
GATEWAY instruction        RESET KEY: Press reset key to clean up all setting parameter. After reset, you need connect gateway to router and launch searching to add devices to gateway. PAIR KEY: Press pair key to launch searching and connecting those un-pairing bulb/sensor devices. Gateway will open to search and add devices about 1 minutes. If you press pair key during the searching step, it will stop the searching process.
PAGE 4
Caution: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.