F- 23 Series Industrial Rem ote Controller Operating Manual R TELECRANE Lee’s Hi-Tech Ent. Co., Ltd.
F-23 Operation Instruction Warranty Lee’s Hi-Tech Enterprises Co., Ltd. guarantees that this product meets its published specifications at the time of shipment from the factory. Under proper installation it should work as expected. Warranty Period This equipment is warranted against defects in material and manufacturing for a period of one year from the date of shipment. During the warranty period, TELECRANE is responsible for necessary repairs as long as the product can be proved to be defective.
F-23 Operation F-23 Standard Accessories When you get a standard and full set of F-23 system, it includes the following item.: (1)Transmitter, one unit. (2)Receiver, one unit. Remarks: (1). (2). (3). Hamming Distance-------------≧4 I.D. Code--------------------------More than 42 billion ID Code(32bit) Channel Spacing----------------267.
F23Transmitter’sparts Emergency stop LED indicator Pushbuttons Remarks: (1). (2). (3). Power----------------------Two 1.
F-23 Receiver’s parts Output cable Remarks: (1). (2). (3). (4). Input Voltage------------------------------110VAC(50/60Hz)±10% Output Relays-----------------------------10A/250VAC. Dimensions---------------------------------290×230×70mm(L×W×H) Weight--------------------------------------about 1900g(W/O wire cable) How to use 1. 2. 3. 4. Insert 2 AA-size alkaline batteries into battery compartment. Insert magnetic key or rotary key and switch to ON position.
5. After operation, please proceed as following: (1) Press EMS pushbutton /mushroom, (2) remove the key and keep it in safe place, (3) Switch off the equipment’s main power (e.g. Crane) How to change quartz from transmitter/ receiver & identify frequency quartz It’s simple to change frequency of the new F23 series. The system’s frequency can be changed simply by replacing correspondent frequency quartz in both the TX and RX.
Transmitter Batteries 2 AA size alkaline batteries are required for the transmitter. DO NOT use rechargeable batteries. During operation, the LED flash green when battery power is full and flash red intermittent every 2 seconds when battery power is low. When battery power is low, the operating distance will become shorter. For safety reason, replace new batteries immediately when battery power is low.
FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.