User's Manual

ManualsBrandsLee's High-Tech ManualsElectronicsIndustrial Radio Remote Controller



1



Lee’sHi‐techEnterprise.Co.,Ltd

1. WARRANTY

1‐1Warranty

Lee’sHi‐TechEnterprisesCo.,Ltd.guaranteesthatthisproductmeetsits

publishedspecificationsatthetimeofshipmentfromthefactory.Under

properinstallationitshouldworkasexpected.

1‐2Warrantyperiod

Thisequipmentiswarrantedagainstdefectsinmaterialandmanufacturing

foraperiodof

oneyearfromthedateofshipment.Duringthewarranty

period,TELECRANEisresponsiblefornecessaryrepairsaslongastheproduct

canbeprovedtobedefective.

Forwarrantyserviceorrepairthisproductmustbereturnedtoaservice

facilitydesignatedbyTELECRANE.Buyerwillpayshippingcharges

to

TELECRANEwhileTEL ECRANEwillpayreturnshippingcharges.

1‐3ExcludedItems

Thiswarrantydoesnotincludeconsumptivepartssuchasbatteries,fuses,

buttons,andrelays.Alsothiswarrantydoesnotcoverdefectscausedby

improperinstallation,improperorinsufficientmaintenance,unauthorized

modification,andimproperoperation,ignoranceofenvironmental

specifications,

orimpropersoftwareorinterfacing.

1‐4Remarks

●Nootherwarrantyisexpressedorimplied,exceptfortheabovementioned.

●Theremediesprovidedhereinarethebuyer’ssoleandexclusiveremedies.

TELECRANEshallnotbeliableforanydirect,indirect,special,incidentalor

consequentialdamages.



2. AT TENTI ON 

2‐1Attention

●Pleasecarefullyreadthemanualbeforeinstallingandoperatingthisdevice.

●Duetothecomplexnatureofthisequipmentitisnecessarytoreadthe

entiremanualbeforeinstallation.

●Neverdismantletheequipmentbyanyunauthorizedpersonnel,or

equipmentmaybedamaged.

●Thismanualisfor

referenceonly.Pleasesconsultyourdistributorfor

furtherassistance.



Usermanual

F21‐E2

Remotecontroller

Summary of content (6 pages)

PAGE 1
F21‐E2 Remote controller User manual Lee’s Hi‐tech Enterprise. Co., Ltd 1. WARRANTY 1‐1 Warranty Lee’s Hi‐Tech Enterprises Co., Ltd. guarantees that this product meets its published specifications at the time of shipment from the factory. Under proper installation it should work as expected. 1‐2 Warranty period This equipment is warranted against defects in material and manufacturing for a period of one year from the date of shipment.
PAGE 2
●The equipment has been strictly tested for quality before delivery from our plant. However, this equipment must not be used in dangerous situations or where damage may result. ●After the operation finished, please close the crane main power source, the receiver power supply. ●Transmitter when not in use, should be placed in a safe place to avoid the accidental touching the buttons by mistake. ●The crane should be equipped with main power relay, limit switch and other safety devices.
PAGE 3
. PROCEDURES OF EMERGENCY In case of an Emergency, please follow the steps below and ask the distributor for service immediately. 1. Press "EMS" button. 2. Turn the key to "OFF" position and remove it. 3. Switch off the main power of crane. 4. Advise the distributor to find out the reason. 4. HOW TO START 4‐1 F21‐E2 feature EMS button LED Indicator Motion button Receiver Wiring diagram Rotary KEY switch 4‐2 Operation 4‐2‐1 Procedure 1. Put two AA batteries on the release ribbon.
PAGE 4
‐2‐2 Transmitter LED indicator There is a 3‐stage power indicating function with LED display. 1."Green color": Sufficient power to operate transmitter. 2."Yellow color": Power is depleting. Operation must be stopped immediately (for example: down the loads to ground) to replace batteries. 3."Red color": Insufficient power. Transmitter will send out an emergency stop signal to the receiver due to insufficient power. Operator should avoid this situation in order to maintain the safety of operation. 5.
PAGE 5
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 6