F25 Industrial Radio Remote Controller Operation Manual ® TELECRANE Lee’s Hi-tech Enterprise. Co., Ltd.
Safety Considerations This product and related documentation must be reviewed for familiarization with safety markings and instructions before operation. Safety Symbols The following symbols may be found on the remote control or throughout the remote control’s documentation. Refer to Manual When product is marked with this symbol refer to instruction manual for additional information. High Voltage Indicates presence of hazardous voltage. Unsafe practice could result in severe personal injury.
Warranty Warranty Lee’s Hi-Tech Enterprises Co., Ltd. guarantees that this product meets its published specifications at the time of shipment from the factory. Under proper installation it should work as expected. Warranty Period This equipment is warranted against defects in material and manufacturing for a period of one year from the date of shipment. During the warranty period, TELECRANE is responsible for necessary repairs as long as the product can be proved to be defective.
Precautions of Operation Attention 1. Never dismantle the equipment by any unauthorized personnel, or equipment may be damaged. 2. This manual is for reference only. Pleases consult your distributor for further assistance. 3. The equipment has been strictly tested for quality before delivery from our plant. However, this equipment must not be used in dangerous situations or where damage may result. 4. After operation, shut off main power to the crane, power to receiver, and remove transmitter key. 5.
Procedures of emergency In case of an Emergency, please follow the steps below and ask the distributor for service immediately. 1. 2. 3. 4. Press "EMS" button. Turn the key to "OFF" position and remove it. Switch off the main power of crane. Advise the distributor to find out the reason. Operation General Operation 1. Install four AA size batteries in the transmitter and make sure the "+" and "-" direction are correct. 2.
Power Supply Selection F25 receiver provides with 4 kinds of Transformer (24V/42V/230V 、 48V/110V/220V、110V/220V/380V、48V/220V/380V) that allows user to choose based on the power input on site and the designated voltage will be set when the receiver is made in factory. Changing power supply voltage 3-4-1 Disconnect the power of receiver. 3-4-2 Remove the connector plug of the transformer from its original position. 3-4-3 Insert the connector plug into the new position. 3-4-4 Complete the procedure.
Transmitter Fault Detection If the LED light on the transmitter is fast flashing in red, then there must be the causes as follows: 1. Some of the push buttons are jammed or stock.. 2. EMS button has not been released. 3. Fail to follow the correct Power-On procedure. This device complies with part 15 of the FCC Rules.
