INSTRUCTION MANUAL RATPAC Connector Kit Build a right angle TA5 or TA3 connector. Fill in for your records: Serial Number: Purchase Date: Rio Rancho, NM, USA www.lectrosonics.
MODEL# Parts Description and Details The RATPAC (Right Angle T connector PACkage) is a versatile kit for building a right angle connector for use with the SR receiver or Lectrosonics transmitters. The 3-pin configuration is normally used for the rear panel audio outputs of the SR receiver. The 5-pin configuration is the standard connector for most belt pack transmitters and the front panel outputs on the 5P version of the SR receiver.
Model Description Larger crimping tabs Smaller crimping tabs Metal retainer Plastic spacer Insert (3-pin or 5-pin) Connector sleeve Backshell (modified or standard) Silicon tubing Tab in keyway NOTE: Larger silicon tubing is normally positioned over the cable clamp after it is crimped. Smaller silicon tubing is normally positioned under the cable clamp before it is crimped. Also see Step 6 below about grounding of some lavaliere mics. Step 1 Install the set screws into the right angle housing.
LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was purchased from an authorized dealer. This warranty does not cover equipment which has been abused or damaged by careless handling or shipping. This warranty does not apply to used or demonstrator equipment. Should any defect develop, Lectrosonics, Inc. will, at our option, repair or replace any defective parts without charge for either parts or labor.