User Manual

Lear Corporation Holding Spain, S.L.U
ElectricalPower Management Systems
Carrer Fusters, 54
Polígono Industrial
P.O. BOX 23
43800 VALLS (Tarragona)
SPAIN
Phone [phone]xxx
Fax [phone]xxx
Inscrita en el Registro Mercantil en el Tomo 1807 de la Sección de Sociedades, Folio 10, Número de hoja T-25.236. C.I.F. B-82055377
VAT:ESB 82055377
Re: Certification for Lear BMW PL7 Front Electronic Module (FEM)
FCC ID: TTRFEMLR01
IC: 6276A-FEMLR01
The device under test is manufactured by the grantee (Lear Automotive (EEDS) Spain, SL) and sold as an
OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-user
has all applicable / appropriate operating instructions.
When end-user instructions are required, as in the case with this product, the grantee must notify the OEM to
notify the end-user.
Lear Automotive (EEDS) Spain, SL will supply the following information to the reseller/distributor dictating
what must be included in the end user’s manual for the commercial product:
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL
The following information must be included in the end product user’s manual to ensure continued FCC
and Industry Canada regulatory compliance. The ID numbers must be included in the manual if the
device label is not readily accessible to the end user. The compliance paragraphs below must be
included in the user's manual.
************************************************************************
FCC ID: TTRFEMLR01 IC: 6276A-FEMLR01
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Note: Changes or modifications not expressively approved by the party responsible for compliance
could void the user's authority to operate the equipment.