User's Manual
Touch and learn!
Touch and learn!
LF915HD
LF915-2HD
5” High Denition5” High Denition
Pan & Tilt MonitorPan & Tilt Monitor
Need help?
Visit leapfrog.com/support
Parent Guide
This guide contains important information.
Please keep it for future reference.
Read our complete warranty policy online at
leapfrog.com/warranty.
Visit our website leapfrog.comleapfrog.com for more information
about products, downloads, resources and more.
Scan the QR
code to enter the
Online Manual:
Or go to leapfrog.com/support
UL STD.
62368-1
CERTIFIED TO
CSA STD.
C22.2 NO.62368-1
CONFORMS TO
Important Safety Instructions
The applied nameplate is located at the bottom of the Baby Unit’s base.
When using your equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and
injury, including the following:
1. Follow all warnings and instructions marked on the product.
2. Adult setup is required.
3. CAUTION: Do not install the Baby Unit at a height above 2
meters.
4. This product is not a substitute for adult supervision of the
infant. Supervising the infant is the parent’s or caregiver’s
responsibility. This product could cease operating, and
therefore you should not assume it will continue working
properly for any given period of time. Further, this is not a
medical device and should not be used as such. This product is
intended to assist you in supervising your baby.
5. Do not use this product near water. For example, do not use
it next to a bath tub, wash bowl, kitchen sink, laundry tub or
swimming pool, or in a wet basement or shower.
6. CAUTION: Use only the battery provided. There may be
a risk of explosion if a wrong type of battery is used for the
Parent Viewer. The battery cannot be subjected to high or low
extreme temperature and low air pressure at high altitude
during use, storage or transportation. Disposal of battery into
fire or a hot oven, or mechanically crushing or cutting or the
battery can result in an explosion. Leaving the battery in an
extremely high temperature surrounding environment can
result in an explosion or the leakage of flammable liquid of gas.
Battery subjected to extremely low air pressure may result in
an explosion or the leakage of flammable liquid or gas. Dispose
of used battery according to the information in The RBRC seal.
7. Use only the adapters included with this product. Incorrect
adapter polarity or voltage can seriously damage the product.
Power adapter information:
Baby Unit output: Output: 5V DC 1.5A; VTech
Telecommunications Ltd.; Model: VT05EUS05150
Parent Viewer output: Output: 5V DC 2A; VTech
Telecommunications Ltd.; Model: VT07EUS05200
Rechargeable battery information:
Zhuhai Great Power Energy Co., Ltd.; Lithium battery, 3.7V
5000mAh; Model: GSP806090-5Ah-3.7V-1S1P
8. The power adapters are intended to be correctly oriented in a
vertical or floor mount position. The prongs are not designed
to hold the plug in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
9. For pluggable equipment, the socket-outlet shall be installed
near the equipment and shall be easily accessible.
10. Unplug this product from the wall outlet before cleaning.
11. Do not use liquid or aerosol cleaners. Use a damp cloth for
cleaning. Do not cut off the power adapters to replace them
with other plugs, as this causes a hazardous situation.
12. Do not allow anything to rest on the power cords. Do not
install this product where the cords may be walked on or
crimped.
13. This product should be operated only from the type of power
source indicated on the marking label. If you are not sure of
the type of power supply in your home, consult your dealer
or local power company.
14. Do not overload wall outlets or use an extension cord.
15. Do not place this product on an unstable table, shelf, stand or
other unstable surfaces.
16. This product should not be placed in any area where proper
ventilation is not provided. Slots and openings in the back
or bottom of this product are provided for ventilation. To
protect them from overheating, these openings must not be
blocked by placing the product on a soft surface such as a
bed, sofa or rug. This product should never be placed near or
over a radiator or heat register.
17. Never push objects of any kind into this product through the
slots because they may touch dangerous voltage points or
create a short circuit. Never spill liquid of any kind on the
product.
18. To reduce the risk of electric shock, do not disassemble this
product, but take it to an authorized service facility. Opening
or removing parts of the product other than specified access
doors may expose you to dangerous voltages or other risks.
Incorrect reassembling can cause electric shock when the
product is subsequently used.
19. You should test the sound reception every time you turn on
the units or move one of the components.
20. Periodically examine all components for damage.
21. There is a very low risk of privacy loss when using certain
electronic devices, such as baby monitors, cordless
telephones, etc. To protect your privacy, make sure the
product has never been used before purchase, reset the baby
monitor periodically by powering off and then powering on
the units, and power off the baby monitor if you will not use
it for some time.
22. Children should be supervised to ensure that they do not
play with the product.
23. The product is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
SAVE THESE INSTRUCTIONS
Cautions
1. Use and store the product at a temperature between 32
o
F and
104
o
F.
2. Do not expose the product to extreme cold, heat or direct
sunlight. Do not put the product close to a heating source.
3. Batteries should not be exposed to excessive heat such as
bright sunshine or fire.
4.
Warning—Strangulation Hazard—Children
have STRANGLED in cords. Keep this cord out
of the reach of children (more than 3 ft (0.9m)
away). Do not remove this tag.
5. Never place the Baby Unit(s) inside the baby’s crib or playpen.
Never cover the Baby Unit(s) or Parent Viewer with anything
such as a towel or a blanket.
6. Other electronic products may cause interference with your
baby monitor. Try installing your baby monitor as far away
from these electronic devices as possible: wireless routers,
radios, cellular telephones, intercoms, room monitors,
televisions, personal computers, kitchen appliances and
cordless telephones.
Precautions for users of implanted cardiac pacemakers
Cardiac pacemakers (applies only to digital cordless devices):
Wireless Technology Research, LLC (WTR), an independent
research entity, led a multidisciplinary evaluation of the
interference between portable wireless devices and implanted
cardiac pacemakers. Supported by the U.S. Food and Drug
Administration, WTR recommends to physicians that:
Pacemaker patients
• Should keep wireless devices at least six inches from the
pacemaker.
• Should NOT place wireless devices directly over the
pacemaker, such as in a breast pocket, when it is turned ON.
WTR’s evaluation did not identify any risk to bystanders with
pacemakers from other persons using wireless devices.
Electromagnetic fields (EMF)
This LeapFrog product complies with all standards regarding
electromagnetic fields (EMF). If handled properly and according
to the instructions in this user’s manual, the product is safe to be
used based on scientific evidence available today.
1 set for LF915HD
2 sets for LF915-2HD
x 2
x 2
Parent Guide
1. Connect the Baby Monitor
Notes:
• Before using the baby monitor for the first time, charge the Parent Viewer battery for 12
hours. When the Parent Viewer battery is fully charged, the battery icon becomes solid .
• The standby time varies depending on your actual usage time and the age of the battery.
Battery Indicators Battery Status Action
The screen displays .
The light flashes.
The battery is low in power and
may only be used for a short time.
Charge without
interruption (about 30
minutes).
The battery icon
becomes solid .
The battery is fully charged.
To keep the battery
charged, connect it to AC
power when not in use.
1. Slide the On/Off switch to ON
to power on your Baby Unit.
2. Press and hold until the welcome screen
appears.
Note:
• POWER LED Light
is OFF by default.
What’s Included
2. Charge the Parent Viewer Battery
3. Power On or Off the Baby Monitor
Connect, Charge, and Power On the Baby Monitor
The battery icon on the screen indicates the battery status:
Press and hold
Note:
• Dim Mode is ON by default so the screen of the Parent Viewer
will dim to conserve energy after 5 minutes of inactivity.
Tip:
• Turn the Dim Mode OFF so that the screen will be on at all
times.
1. Press MENU/SELECT to enter the main menu.
2. Select LCD Settings Menu , then choose Dim Mode.
3. Slide the button once to turn the dim mode off.