RadioPopper JrX Radio Wireless Owners Manual
RadioPopper is owned and manufactured by Leap Devices, LLC in Phoenix Arizona. This product was designed, produced, and manufactured in the USA. FCC STATEMENT This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Table of Contents IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the following antenna installation and device operating configurations must be satisfied - This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. PRODUCT PATENT(S) PENDING Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Specifications and Warnings . . . . . . . . . . . . . . . .
RadioPopper JrX Radio Wireless System Introduction Thank you for your purchase of the RadioPopper JrX wireless radio system. We hope you’ll find this system to be a valuable tool in your creative lighting, giving you flexibility and control never before possible. The RadioPopper JrX system is a high quality and highly reliable radio triggering system. The JrX provides long range triggering of lighting equipment, as well as integration and compatibility with RadioPopper JrX units.
Introduction Page 5
RadioPopper JrX Radio Wireless System Compatible Hardware: The JrX System has been tested and found to be compatible with the following flash hardware. See our website for updates as we test and certify compatibility with additional hardware. Transmitter: May be used with any camera with a standard hotshoe mount. May also be used via an external PC Sync cable appropriate to your particular brand of camera.
Specifications and Warnings WARNING!!! WARNING!!! WARNING!!!! PLEASE read this section in detail for important warnings and notices. USE ONLY THE SUPPLIED TRANSMITTER ANTENNA! Using any antenna other than the one supplied for use with your JrX Transmitter is a violation of Federal Law and may actually cause damage to the radio inside the transmitter. This will also promptly void your warranty. Your JrX Transmitter has been carefully tuned to broadcast the maximum signal strength allowable by law.
RadioPopper JrX Radio Wireless System Page 8
Parts Description Page 9
RadioPopper JrX Radio Wireless System Installation & Basic Operation: RadioPopper JrX Transmitter 1) Remove the battery compartment door on the top side of the unit. Insert a single CR123 Lithium battery. Take care to follow the direction / polarity indications printed inside the battery clip. Secure the battery by pressing it straight down into the clip - it will click into place. Replace the battery compartment door.
Installation Installation & Basic Operation: RadioPopper JrX Receiver 1) Remove the battery compartment door on the top side of the unit. Insert a single CR123 Lithium battery. Take care to follow the direction / polarity indications printed inside the battery clip. Secure the battery by pressing it straight down into the clip - it will click into place. Replace the battery compartment door.
RadioPopper JrX Radio Wireless System Option Switch Operation: Adjust the settings on your JrX Transmitter and JrX Receiver units using the Option Switches provided along the side of either unit. The switches are labeled from “1” to “6” on the JrX Transmitter, and from “1” to “8” on the JrX Receiver. Please refer to the following description and tables for details. Radio Channel - The radio channel on your JrX Transmitter or JrX Receiver is set by the positions of the first four switches.
Installation Page 13
RadioPopper JrX Radio Wireless System Canon is a registered trademark of Canon Inc. in the United States and may also be a registered trademark ortrademark in other countries. ITTL stands for Intelligent Through The Lens, the trade-marked name for Nikon’s exposure measurement system on SLR cameras. Nikon is a registered trademark of Nikon Corporation. All other product and brand names are trademarks of their respective owner.
Limited Warranty LIMITED WARRANTY The Limited Warranty set forth below is given by Leap Devices LLC (hereafter “Leap”) in the United States with respect to the RadioPopper JrX Transmitter and / or RadioPopper JrX Receiver packaged with this Limited Warranty and identified by model number within this Limited Warranty (each a “Product”) when purchased and used in the United States or in Canada. This Limited Warranty is only effective upon presentation of this warranty card and proof of purchase.
Copyright 2007-2009, Leap Devices LLC, All Rights Reserved