Leadtek GPS LR9580 Bluetooth GPS receiver Quick Installation Guide FCC CE SRRC BT 1. Package 1. LR9580 main unit *1 2. USB cable *1 3. Car charger *1 4. Quick Installation Guide *1 5.
. Specifications ◎Technical specification Feature Item Description Chipset MT 3318f +6601 GPS single chip + Bluetooth chipset General Frequency L1, 1575.42 MHz C/A code 1.023 MHz chip rate Channels 14/32 Position 3 meters, 2D RMS Accuracy 2.5 meters 2D RMS, WAAS corrected <2.5 meters (50%) Velocity 0.1 meters/second Time 1 microsecond synchronized to GPS time Default WGS-84 Other selectable for other Datum Time to First Fix Reacquisition 0.1 sec.
◎Environmental Characteristics Items Description Operating temperature range -10 deg. C to +50 deg. C Storage temperature range -20 deg. C to +65 deg. C ◎Physical Characteristics Items Description Length 75.6mm ± 0.12 mm Width 28.4mm ± 0.08 mm Height 18.7mm ± 0.08 mm Weight 38 g (including rechargeable battery) ◎Interface Specifications Items Description V1.
◎Electrical Specifications Power Item Description Main power input DC 3.3~5.0V Power consumption 185 mW (Acquisition mode) 106 mW (Tracking mode) Supply Current 56 mA@3.3VDC (Acquisition mode) 32 mA@3.3VDC (Tracking mode) Battery Item Description Model Type Lithium ion Polymer Capacity 670mAh Nominal Voltage 3.7V Weight 12.
3. Getting Started 3.1Charge Charge with your USB cable (via PC) or Car charger (via Car cigarette) 3.2 Power Pull the switch on to turn on LR9580. 3.
Non-slip design 3.3 LED Display LED 1 (GPS)-Green State Always on Quick blinking Slowly blinking Description Memory full to stop 3D fixed GPS signal acquisition State Quick blinking Slowly blinking Description BT on, but not connected yet BT connected State Always on Quick blinking No Description Battery is charging Low power Battery is fully charged LED 2 (Bluetooth)-Blue LED 3 (Power)-Red 3.
Step 1 First, turn your Bluetooth device on (for example, your PDA), and activate the Bluetooth manager program. Secondly, turn the LR9580 on, and the Bluetooth LED indicator starts quick blinking. Step 2 Wait a while, tap the device name “LR9580” once it is found in your PDA, and select SPP slave to add LR9580. When password is required, enter “0000”. Step 3 Once connected, the blinking starts to get slower. Now you can start your navigation with the map software in your PDA.
4. Safety Information GPS is operated by the US government, which is solely responsible for the system’s accuracy and maintenance. Although Leadtek GPS LR9580 is a high precision electronic NAVAID, it may still become unsafe under the circumstances of misuse or inaccurate reading. Hence there is a certain degree of risks involving the use of these products. In order to reduce the risks, please read carefully all the documentation regarding technical specifications before using Leadtek GPS LR9580.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.