User's Manual

125 mm
90 mm 90 mm 90 mm
When using this product, basic precautions should always be followed, including the following:
a. Read all the instructions before using the product.
b.Toreduce the risk of injury, close supervision is necessary when the product is used near children.
c. Do not put finger or hands into the product.
d. Do not expose product to rain or snow.
e. Using the product incorrectly may result in the risk of fire or injury to persons.
f. Do not use the product in excess of its output rating.
Overload outputs above rating may result in a risk of fire or injury to persons.
g. Do not use the product that is damaged or modified. Damaged or modified product may exhibit
unpredictable behavior resulting in fire, explosion and/or risk of injury.
h. Do not disassemble the product.Takeit to a qualified service person when services or repair is
required. Incorrect reassembly may result in a
risk of fire or injury to persons.
i. Do not expose product to fire or excessively high temperatures.
Exposure to fire or temperature above 113°F (45°C) may cause explosion.
j. Have servicing performed by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the product is maintained.
k. Switch off the product when not in use.
FCC statement
Important Safety Instructions
Magnetic Wireless Charger with Phone Stand
User manual
Product Overview:
Specifications:
Operation:
Input: DC 5V/2A, 9V/2A
Wireless Output: DC 5V/1A, 9V/1.1A
Working Distance: 2~4 mm
TYPE-C
Charging area
Indicator Light
Instruction sheet
1
2
3
4
4
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This device generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this device does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the device and receiver.
--Connect the device into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment
3. The distance between user and products should be
no less than 20cm
The distance between user and products should be no less than 20cm