Instruction Sheet

Wireless Charger Instruction
Sheet
Wireless Charging Method
Size: 14x10 cm
USB Power Cable attached
Charging area
The diagram of installation
1.Connect wireless charging pad to a power source via included
USB cable.
2.Place your portable device in the center area of the charging
·Reorient or relocate the receiving antenna.
·Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Made in China
pad to begin charging.
Product specs:
Product model: AB0124
ITEM: 5147
Input Specs:DC:5V/1.5A
Output Specs:5V,1000mA
Conversion efficiency: 70%
Working frequency:111.5-205KHZ
FCC ID: 2APYY-AB0124
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generate, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
The distance between user and products should be no less than 20cm