Instruction Manual

1.
•
•
**
MADE IN CHINA
INSTRUCTIONS:
Wireless Charging Function:
Once connected the LED indicator will
is in standby mode and is ready to begin
charging.
Place the wireless charging supported
device on the charging surface(1),the
device will begin to charge automatically.
(LED will glow WHITE when device is
charging).
Note: When wireless charging, if the LED
NOT a wireless charging device or there is
an object between the device and charging
surface interfering with the charging
process.
Ultra Thin Fabric
Wireless Charging Pad
Instruction Manual
7141-83
1 x Wireless Charging Pad
1 x Instruction Manual
Input power: 5V/1.5A
Wireless Charging Output: 5V/1A
1.
2.
•
•
Wireless Charging Surface
USB Input Cable
What’s included:
Features:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful
interference, and
This device must accept any interference
received, including interference that may
cause undesired operation.
Warning:
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
(1)
(2)
*
FCC Statement:
Do not expose the device to moisture.
Do not use the device in excess of its
output rating. Overload outputs above the
Do not use the device if damaged or
explosion or risk of injury.
Do not disassemble the device. For repairs,
Incorrect reassembly may result in a risk of
or temperatures above 104°F (40°C) may
result in explosion.
To ensure product safety, ensure that
identical replacement parts.
Attachments on the back of your phone can
impede the effectiveness of the wireless
charger, and lead to overheating. You must
remove attachments from the phone before
charging on this device.
5.
6.
7.
8.
9.
10.
11.
12.
WARNING-When using this product, basic
precautions should always be followed:
Read all the instructions before use.
Never store or use this product in
temperatures below 32°F (0°C) or above
115°F (45°C).
Do not overcharge your phone. The
unit may become hot under excessive
use. Remove your phone once it is fully
charged. Never charge your phone for
more than 7 hours at a time.
To reduce the risk of injury, close
supervision is required when the product is
used near children.
•
1.
2.
3.
4.
SAFETY PRECAUTIONS:
FCC Warning Statement
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment. This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐ Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.