Installation Instructions

JAHD240BT Waterproof
Heavy Duty Two
Channel
Audio Amplifier
Features
˙ Bluetooth Audio (A2DP)
˙ 2 x 40 Watt Max Power Rating
˙ 2 x 20 Watt RMS
˙ 4 Ω – 8 Ω (ohm) Stable
˙ Frequency Response: 20 Hz – 20 kHz
˙ Epoxy Potted Enclosure
˙ 10 Amp Fuse in Waterproof Holder
˙ Waterproof to IPx6
˙ Corrosion Resistant to ASTM B117
Wiring
Black
Ground
Yellow
+12V Battery
Red
+12V Switched
Gray
Right Front Speaker +
Gray / Black
Right Front Speaker –
White
Left Front Speaker +
White / Black
Left Front Speaker –
Installation
1. Choose a smooth, flat, sturdy location that
will allow the JAHD240BT amplifier to be
mounted securely and allow enough room
to run the connection wires.
2. Mount amplifier using #8 stainless steel
screws (not included)
3. Drill 5/8” hole in desired location, install
switch and route cable from desired location
to the amplifier
4. Route and connect power, ground, and
speaker cables (see reverse page)
Important:
Do not mount unit where it can be submerged
Do not mount near engine or areas exposed to
excessive heat
Yellow
Red
Black
Gray/Black
Gray
White/Black
White
Bluetooth Antenna
DO NOT CUT/CONNECT
10 A Fuse
Switch Cable
Switch Cable
Power/Pairing Switch
#8 Stainless
steel screws
RF Exposure Statement
To maintain compliance with FCC's RF Exposure guidelines, This equipment should be
installed and operated with minimum distance of 20cm the radiator your body. This device
and its antenna(s) must not be co-located or operation in conjunction with any other
antenna or transmitter.