Installation & Assembly

ASSEMBLY/INSTALLATION INSTRUCTIONS

1-LIGHT OUTDOOR

installation.

shock.

All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)

standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a

referencing the illustrations on the installation instructions.

Phillips screwdriver.

1. Gently take all parts out of the package, lay them on a smooth surface, unscrew the BALL NUTS and

the FIXTURE SCREWS. Attach the CROSS BAR to the JUNCTION BOX using (2) JUNCTION BOX

SCREWS.

2. Make wire connections with WIRE CONNECTORS:

A - Connect the black wire from Fixture to the black supply wire.

B- Connect the white wire from Fixture to the white supply wire.

it to the supply ground wire with a WIRE CONNECTOR. Carefully tuck wires back into the JUNCTION BOX.

3. Attach the FIXTURE to the CROSS BAR through SCREW HOLES as shown, and secure it with BALL NUTS

and RUBBER RING.

5. Install BULB(not included). See relamping label at socket area or packaging for maximum allowed wattage.

CAUTION

GENERAL

TOOLS REQUIRED

ASSEMBLY AND INSTALLATION

(CONT.)

Turn off the power at fuse or circuit breaker.

Turn on the power at fuse or circuit breaker.

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN.

Please read carefully and save these instructions, as you may need them at a later date.

NOTICE: Please use caulk in the back plate and wall mounting surface to prevent water from entering.

4. Attach the SHADE onto SOCKET using SOCKET RINGS.