User's Manual

LAUNCH
Quick Start Guide
CRP329
Product Profile
CRP329 System
CRP329 is a stylish Android-based diagnostic device developed by LAUNCH. It inherits from
LAUNCH's advanced diagnosing technology and is characterized by covering a wide range of
vehicle models, featuring powerful functions, and providing precise test result.
Through simple wireless communication, it achieves full car model and full system vehicle
trouble diagnosis. In addition, CRP329 supports network connection, one-click update and all
kinds of resetting operations(including oil lamp reset etc).
VCI Connector
OBD II 16pin connector
(For connecting to vehicle’s DLC)
The VCI connector only applies to the passenger vehicles of 12V. It can be installed on the
OBD II vehicle’s DLC directly or via the extension cable.
The CRP329 system is mainly composed of CRP329 tablet and VCI connector. The following
illustration explains how the CRP329 tablet works with the VCI connector.
(For details on how to
connect, please refer to
Section 4 “Preparation
& Connections”.)
To proceed one of the following operations, you need
to make network connection (See Section 2
“Network Setup” for details):
 Register & activate CRP329, update the diagnostic
software & APK
 Work on golo module
 Surf the Internet
*Note: Remember to remove the
VCI connector from the DLC
and re-insert it into the slot on
the back of the tablet after use to
avoid loss.
Charging & Turning On
1
1. Connect the power adaptor to the Universal Serial BUS port of the tool.
2. If the tool is being charged, a charging indicator displays . Once the indicator turns ,
charging is complete.
3. Pressing the POWER button will start the tool and enter the home screen.
Note: On first use of the tool, or if the tool remains idle for a long period of time, there may be
insufficient battery power to start the tool. Please charge for a minimum of 5 minutes before
attempting to turn it on again. Please use the power adaptor included within the kit to charge the
tool. No responsibility can be assumed for any damage or loss caused as a result of using any
power adaptor other than the one supplied.
Network Setup
2
CRP329 supports WLAN connection. To enable you to surf the Internet, register App,
launch golo module and update the diagnostic software etc, please follow the steps
below to configure the network:
1. On the home screen, tap “Settings” > WLAN.
2. Slide the WLAN switch to ON, the system starts searching for available WLAN
networks.
3. Select a wireless network. If the chosen network is open CRP329 will connect
automatically, if the selected network is encrypted, a network password will need to be
entered.
4. When “Connected” appears, it indicates the tablet is properly connected to the
Internet.
*Note: when WLAN is not required this should be disabled to conserve battery power.
CRP329 Tablet
(Works as the central processor and
monitor for analyzing vehicle data
and indicating the test result.)
VCI Connector
(Works as the vehicle
communication interface device
for accessing the vehicle data.)
Vehicle
To Vehicle’s DLC
(Sending the vehicle data to CRP329 tablet)
Internet
DS401