User's Manual

Revision 1.1
July 10, 2013
1
Instruction Manual
1. Introduction
This watch has basically 5 modes :
(1) Real time clock mode
(2) Workout mode
i. Distance View
ii. Pace View
iii. Calorie view
iv. Heart rate view
(3) Chronograph mode
(4) Count down timer mode
(5) Alarm mode
2. Operation Procedures for accessory connection
Press MODE key to toggle between different modes.
RTC  Workout Mode (Distance  Pace  Calorie  Heart rate) 
Count down timer  Alarm mode  RTC
In figure 1 (on the left hand side), it shows the watch is at RTC mode. Press mode key 3 times to enter
workout mode heart rate view. It should be similar to that in figure 2 ( on the right hand side).
When entering workout view, the watch will start scanning when it stays at a view for 5 seconds. After
that, it will start scanning for 30 seconds and look for a peer BLE device which contains a heart rate
profile. As shown in figure 2, the heart symbol in the yellow circle will blink. After 30 seconds, it will
stop scanning if no connection is made. Otherwise, the heart rate symbol in the yellow circle will stay
on.
Figure 1 Figure 2