Owner Manual (Platform Bed)

1 of 4

before starting the assembly.

To make the assembly simple and well done, you have to be familiar with the parts.

Follow the step-by-step instructions on a clean area ( ex. carpet). Read the instructions

ASSEMBLY INSTRUCTIONS, PLATFORM BED 60''

Special Notes :

Assembly tools required : Hammer, Phillips screwdriver #2 and #3

ITEM QTY DESCRIPTION

1 2 Side rails

2 1 End rail

3 2 Left and right sides

4 1 Front panel

6 5 Top panels

7 2 Cross-piece supports, long

8 3 Cross-piece supports, short

PAGE 1
ASSEMBLY INSTRUCTIONS, PLATFORM BED 60'' Assembly tools required : Hammer, Phillips screwdriver #2 and #3 Special Notes : To make the assembly simple and well done, you have to be familiar with the parts. Follow the step-by-step instructions on a clean area ( ex. carpet). Read the instructions before starting the assembly.
PAGE 2
Pre-assembly check list hardware pack ITEM 9 : 40x ITEM 10 : 41x M8 assembly screw Screw #8 - 1" ITEM 12 : 4x Glide 2 glides on this part ITEM 13 : 16x Screw cap barbed dowel 5mm Step 1 ITEM 11 : 13x Screw holes on top 12 4X Sub-assembly upright 7 1/2'' thick 3 8 1/2'' thick 7 1/2'' thick 8 8 4 5/8'' thick 3 9 16X Edgebands this end 11 13X Install glides on panels individually first Step 2 6 9 24X 6 6 6 6 13 16X 2 of 4
PAGE 3
Step 3 Tilt assembly on a block for easier screwing 1 b) Align with end rail, parallel to bed( 3/8'' gap), secure 1 a) Center and secure end rail first 2 10 41X Align pieces, 2 sides 2 mm 5/64'' gap approx. No gap fit 2 mm 5/64'' gap approx.
PAGE 4
Warranty Garantie The warranty covers defects in material and workmanship for a period of one year from the date of purchase. The original purchase receipt is required as proof of purchase. This warranty is limited to the replacement of defective parts. This warranty does not cover normal wear and tear, scratches, alterations and intentional and non-intentional damages. This warranty does not cover the product if it has been placed outdoors or in a humid environment.