UIDE USE AND D CAR RE GU __________ _____________ ____________ __________________________ FLO OOR/W WALL FOUNTA F AIN
UCTIONS EMBLY INSTRU ASSE READ AND SAVE E THESE INSTRUCT TIONS Read innstructions all a the way through t prioor to assem mbly. This fouuntain shouuld take apprroximately 15 minutes to assemble. Make suure all partss are firmly tightened. TOOLS S REQUIRE ED: Level, P Pencil, Philllips screwdriver.
FOUNT TAIN ASSE EMBLY 1. Rem move roof frrom the fou untain body,, then remov ve water difffuser (D) fr from top of the t founntain body. 2. Rem move plasticc cover from m water difffuser (D) an nd replace th he water difffuser (D) back b into the top of the fountain fo bod dy. 3. Attaach LED cluuster assem mbly (C) braccket into metal slot on the back off fountain body as show wn. m LED clustter assemblyy (C) behind d metal braccket (follow wing the water 4. Feedd cord from tubee). 5.
6. Peeel paper backking from the wall spaacer pad (J) and apply to back of thhe basin as shown. s FOR W WALL MOU UNTED AP PPLICATIIONS: A1. Loocate desiredd position on o the wall. Use a level to draw a line on the w wall, place bracket b (E) to the walll and mark three mounnting holes. A2. Bassed on youur specific wall materrial (wallbo oard, sheet rock, plasster, concreete etc.
A5. Aliign bracket (E) on the wall with bbracket on the back off fountain, hhang fountaain body seccurely on bracket b (E) attached tto the wall,, make sure the brackket on the back of fouuntain is onn the top of the t wall braacket (E). A6. Too install the anchors (M M) for the coord cover ch hannel (G), place p the coord cover ch hannel (G G) on the waall and mark k two mountting holes. Gently G tap or o press the tip into thee dryywall, makee sure the fllat side of thhe anchor iss flush with the wall.
FOR FLOOR AP PPLICATIO ONS: B1. Feeed pump (A) power corrd through tthe hole in back b of the fountain boody. Make sure the lighht cord is beehind the meetal brackett (Ref: Step #4), then jo oin the lightt connectorss and screew the cap to t connect th he parts tighhtly togetheer. B2. Inseert pump coonnector (K K) into the hoole of pump p (A), then place p the puump (A) intto the basiin. B3. Place the founttain body on nto the desiired flat floo or and against the w wall. 7.