BRM - Manual Zach Dickerson, PE, 6/10/2020 *The BRM is exactly the same as all other rifles (BRP, XL) except it has additional options for recoil, reload and adjustable stock. Reload the BRM Squeeze and pull to remove magazine. If magazine Flip enabled, then flip magazine over.
Push magazine back into the chamber until it clicks and locks into place. If flip and Charge are enabled, then afterward you need to pull the charge handle out. Release the handle and it should snap back into place, you should hear the weapon complete the reload cycle. *Note, ● If using a sniper rifle, by default you will need to pull the handle between each shot (bolt reload type). ● If using a Shogun, you will need to pull the charge handle and hold it to continue loading shells (shell reload type).
All reload settings can be configured like below, to make the weapon more or less realistic. If you only want to remove mag and reinsert If you want to remove mag, then flip it over to reload on insert If you want to remove mag, flip it over, reinsert, then pull charge handle (most realistic) If you ONLY want to pull the charge handle to reload weapon If you want to ignore all realistic reloading and just press the red button on grip to reload Always remember to save settings on exit.
BRM Recoil Recoil motor location: Recoil motor tube will get warm to the touch at high rates of fire. If it ever gets very hot to touch, lower the rate of fires intensities in menus below. To Adjust recoil settings: You can adjust the intensity of recoil at different gun rates of fire, for instance it is best to leave recoil strong at low rate of fire, and weaker at high rate of fire, or the motor may ‘skip beats’. We suggest leaving these at default settings below.
Very fast fire weapons (least recoil felt) Advanced menu to control how quickly the gun will limit the recoil to avoid overheat (such as if you made all weapons have 100% recoil power, this will clamp the motor after X bullets to cool it down for Y seconds). Suggested to leave all these menus at defaults. Always remember to save settings on exit. Adjust the Stock Adjust the stock by squeezing the handle and pulling/pushing to move to the desired length.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.