User Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
GL-30100
REPROGRAMMING THE REMOTE
NOTICE
 The remote control is a transmitter. The light contains a receiver.
 The light is always “hot”. The light is constantly listening for a transmitter as long as it is
connected to power.
 Thus it is critical that you disconnect the power from the light you do not wish to
reprogram.
 All lights within 200 feet of a controller (transmitter) must be disconnected from their
power before completing this procedure.
1. Golight controllers have a series of dip switches on the back of the controller. The dip
switches are accessed by removing the battery cover. By default, all dip switches are set
to the zero position. Moving any one dip switch changes the channel for that
transmitter (controller). Once you have changed a dip switch, proceed to step 2.
2. Disconnect the power to the light you wish to control with the transmitter with the new
dip switch setting. For cigarette plug models, this means pulling the cigarette plug out of
the socket. For hard wired models, you may need to physically separate the crimped
connection. On vehicle installations, you might need to pull the fuse for that connection.
3. Press and hold down the ON/OFF button on the transmitter (controller).
4. Continue to hold down the ON/OFF button on the transmitter (controller) while
reconnecting the power to the light. Wait 5-8 seconds. The light bulb should turn on.
5. Now, that remote controller will communicate with the light only.
NOTE: When you install multiple Golights on one vehicle, vessel or other single power
source, connect each Golight to a separate fuse.