Specification Sheet

Page: 1
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
4 Plug Multiport AC to DC transformer converts 120-277 volt AC to 12/24 Volts DC - 25 Amp Max
Part #: DCP-25-4XDP
The Larson Electronics DCP-25-4XDP Waterproof Power Supply converts commonly used 120 - 240VAC electrical current to 12VDC
@25 Amps. This converter includes a typical straight blade plug on the input end and four 2-prong Deutsch connectors on the output
end. This unit takes voltages within the 100-277VAC range and reduces it to 12/24 VDC, allowing users to use standard AC power to
operate equipment like our LED light bars and HID Golights that require low voltage DC current.
The DCP-25-4XDP 256 watt power converter provides a safe and effective way for users to tap into and utilize common 120 to 240 Volt AC
power sources and convert this current to 12/24 Volts DC for use with equipment that requires 12/24 volt electrical power. This unit can be
operated with input current ranging from 100 to 277 VAC and will output 256 watt 12 Volt DC current at 25 amps or 24 Volt DC at 12.5 amps.
This power converter features an IP67 rated waterproof design, making it suitable for indoor or outdoor use and is wet-damp area approved. This
converter includes integral short circuit, over voltage, over temperature and overload protection that will shut down the unit or reduce output in
case of faults and overloads to protect the unit and connected equipment from damage.
The small size and wide input voltage range of this unit make it ideal for indoor-outdoor operation of Larson Electronics LED light bars, Golights
and other equipment that requires 12/24 VDC current and anywhere 12/24 volt DC power is not readily available. Measuring 9.6 inches long by
2.6 inches wide by 1.5 inches deep, this unit weighs approximately one pound and is mounted with two conventional screws via slots that allow
removal and repositioning simply by loosening the screws.
This converter comes with a straight blade plug on the input lead and four two-pin Deutsch connectors on the output lead, allowing users to run
four fixtures off one transformer, keeping in mind that the total amperage should ideally be kept within 75% of the unit's total amperage output
and not surpass its amperage maximum (25 amps @ 12VDC, 12.5 amps @ 24VDC). Most of our 12 volt LED lights and LEDLB, LEDLB-E,
LEDP series lights as well as many of our HID units utilize Deutsch connectors, making this unit "plug-n-play" compatible. This converter will also
work with our HML-1, CML-1, CML-2, HML-2, CML-3, HML-3 and CML-4 and HML-4 series spotlights. THIS WILL NOT WORK WITH THE HID
GOLIGHT SPOTLIGHTS (GL-3XXXH-X models). If you purchase this transformer with any of our Larson Electronics lights, we will make sure
that the connectors are a match.