Specification Sheet

Page: 1
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
Multiport AC to DC transformer converts 120-277 volt AC to 12/24 Volts DC up to 106 Watts
Part #: DCP-11-2XDP
The Larson Electronics DCP-11-2XDP Waterproof Power Supply converts commonly used 100-277VAC electrical current to 12VDC @11
Amps. This converter includes a typical straight blade plug on the input end and two 2 prong Deutsch connectors on the output end,
allowing multiple devices to be run with this unit. This converter can operate with voltages within the 100-277VAC range and converts
it to 12VDC or 24VDC, allowing users to operate equipment like our LED and HID lights that require low voltage DC current from
standard AC power.
The DCP-11-2XDP 106 watt power converter provides a safe and effective way for users to tap into and utilize common 100 to 277 Volt AC
power sources and convert this current to 12 Volts DC for use with equipment that requires 12 volt electrical power. This unit can be operated
with input current ranging from 100 to 277 VAC and will output 12 Volt DC current at 11 amps or 24 Volts DC at 6.25 amps. This power converter
features an IP67 rated waterproof design, making it suitable for indoor or outdoor use and includes integral short circuit and overload protection
that will shut down the unit in case of faults and overloads to protect the unit and connected equipment from damage.
This converter comes with a straight blade plug on the input lead and a Y connector ending in two 2-pin Deutsch connectors on the output lead,
allowing users to run 2 fixtures off one transformer, keeping in mind that the total amperage should ideally be kept within 75% of the unit's total
amperage output and not surpass its 11 amp maximum. Most of our 12 volt LED lights and LEDLB, LEDLB-E, LEDP series lights as well as
many of our HID units utilize Deutsch connectors, making this unit "plug-n-play" compatible. This converter will also work with our HML-1, CML-1,
CML-2, HML-2, CML-3, HML-3 and CML-4 and HML-4 series spotlights. THIS WILL NOT WORK WITH THE HID GOLIGHT SPOTLIGHTS (GL-
3XXXH-X models). If you purchase this transformer with any of our Larson Electronics lights, we will make sure that the connectors are a match.
The small size and wide input voltage range of this unit make it ideal for operating Larson Electronics LED light bars, Halogen Golights and other
equipment that requires 12VDC current indoors and anywhere 12 volt DC power is not readily available. Measuring 8.7 inches long by 2.5 inches
wide by 1.5 inches deep, this unit weighs less than one pound and is mounted with two conventional screws via slots that allow removal and
repositioning simply by loosening the screws.