Specification Sheet

Page: 1
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
LED Spreader Deck Light- (4) LEDS- White Aluminum Housing - Dual Colors - Dimmable
Part #: LED-SL-4-2C
Made in the USA
The LED-SL-4-2C LED spreader light from Larson Electronics contains 4 LEDs and produces 972 lumens of dual color light in a
circular flood pattern while drawing only 10.8 watts on a 12 volt electrical system. This compact and fully sealed LED spreader light
can be operated on voltages ranging from 10 to 30 VDC and is ideal for use in marine environments as deck lighting, cockpit or cabin
lighting and anywhere a high quality, bright light is desired.
This LED spreader light is designed for marine use and is an ideal alternative to, or upgrade from, the common 55 watt halogen lamps used on
boats and yachts to illuminate bridges, cockpits, cabins and decks. These LED spreader lights produce 972 lumens of high quality light and draw
only 880mA when connected to a 12 volt electrical system, resulting in up to 80% lower power consumption when compared to the halogen
lamps they are designed to replace. The light produced by this unit is very evenly distributed in a circular flood pattern approximately 16' in
diameter and much purer and clean without the yellowish tint often associated with halogen or incandescent lamps. This LED light is completely
sealed making it IP67 compliant and waterproof.
Click here to read an article on the advantages of LED Boat lights over incandescent, fluorescent, or HID Boat lights.
This unit’s housing is constructed of die cast aluminum with a white powder coat finish for high durability and fully sealed against intrusion from
water or dust making it IP67 compliant. Measuring only 4.5 inches long by 1.6 inches wide, this very compact LED spreader light fixture is
designed for stud mounting with a single 1/4-20 stud mount on a pivoting bracket for easy installation. The pivoting bracket allows adjustment of
the fixture to any angle and a simple nylock secures the angle of the light once positioned. Connection to power is via two simple power leads
and the unit can be operated on voltages ranging from 10 or 30 VDC without any modifications necessary. The LEDs and sealed construction of
this unit provide 50,000+ hours of LED operation with minimal maintenance or upkeep requirements.