Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
LED-SL-4-2C
INSTALLATION INSTRUCTIONS:
1. Select mounting location. At a mounting height of 8 feet, a primary illumination area
approximately 1 foot in diameter will be brightly lit. A secondary illumination area considerably
larger than this will also be lit, albeit to a lesser degree. Illumination areas will change based on
the mounting height and light angle. Select a mounting height and location best suited to your
particular needs.
2. Securely mount and position the light using the mounting hardware provided.
3. Establish the electrical connections per ABYC guidelines. Device is polarity sensitive. Light
draws approximately 1A at 12vdc, .5A at 24vdc. Ensure the gauge of the power wires and the
fuse configuration is appropriate for the specific installation. For optimal performance and
reliability, a completely sealed wire to wire connection, such as an adhesive-lined butt
connector.
Note: Your flood light may become warm or hot to the touch during normal operation. This is not
damaging to the light or to normal mounting surfaces but care should be taken to avoid injury. The light
should not be installed in enclosed or confined spaces which restrict airflow to the lights cooling fins.
Overheating may cause the light to shut down partially or completely. If this occurs the light should be
turned off and allowed to cool fully. Ensure that the light has ample air circulation before turning the
light back on.
2 – COLOR OPERATION WITH DIMMING
Note that the light ramps in intensity over a period of about 3 seconds on startup. With no interruption
of this ramp, the light will achieve and maintain full intensity. To enable a “dimmed mode” simply
interrupt the ramp in intensity with a brief off/on toggle of the power. This allows the intensity to be set
anywhere from a soft glow to full power. A subsequent off/on toggle will allow the light to change
colors.
LIMITED WARRANTY
The product is warranted to be free from defects in workmanship and materials for a period of one year
from the date of original purchase. We are not responsible for product failure caused by abuse, neglect,
improper installation, or failure in applications other than those for which it was designed, intended and
marketed. Should your product prove defective during the warranty period, promptly notify us and
return the product at your expense.