Datasheet

00100004
DATA SHEET
valid from:
06.02.2019
Creator: HESC / PDC
Released: ALTE / PDC
Document: DB00100004EN
Version: 04
Page 1 of 1
We reserve all rights according to DIN ISO 16016.
PD 0019/05_04.18EN
Application
dium
mechanical use. They are suitable for use in dry, damp and wet areas and are space-saving due to smaller cable diameters. If using outdoors,
observe the indicated temperature range and use with UV protection. They are largely resistant to acids, alkalis and certain oils at room
temperature.
-automated movements. They meet the requirements for slow
rotational movements, such as in the loop of a wind turbine. The maximum tensile load is 15 N/mm² of conductor cross-section during
installation and operation. Compulsory guidance is not permitted.
Application range:
stations, in heating and air-conditioning systems, etc.
This cable is suitable for torsion application in wind turbines (WTG). The torsional load is limited to applications, as they typically occur in the
loop of a wind turbine.
Design
Design
based on
EN 50525-2-11 resp. VDE 0285-525-2-11
EN 50525-2-51 resp. VDE 0285-525-2-51
Conductor
bare copper, fine wire strand in acc. with IEC 60228 resp. VDE 0295, Class 5
Insulation
PVC compound TI2 acc. to EN 50363-3 resp. VDE 0207-363-3
with increased requirements acc. to Lapp specification
Core identification code
acc. to. VDE 0293-1, with or without GN/YE protective conductor
with up to 5 cores: acc. to VDE 0293-308 / HD 308 S2
more than 6 cores: acc. to LAPP-
Stranding
cores are stranded in layers
Outer sheath
PVC compound TM2 acc. to EN 50363-4-1 resp. VDE 0207-363-4-1
with increased requirements acc. to LAPP specification
colour: silver grey, similar RAL 7001
dlsafjlöj f
Electrical properties at 20°C
Specific volume resistivity
> 20 G Ω x cm
Rated voltage
U₀/ U: 300 / 500 V
Test voltage
core/core: 4000 V AC
Mechanical and thermal properties
Minimum bending radius
occasional flexing: 15 x cable diameter
fixed installation: 4 x cable diameter
Temperature range
occasional flexing: - 5˚C up to +70˚C max. conductor temp.
fixed installation: - 40˚C up to +80˚C max. conductor temp.
Torsional stress
in WTG:
TW-0 (5000 cycles at ≥ +5˚C)
TW-1 (2000 cycles at ≥ -20˚C)
± 150˚/m at 1 revolution per minute
Flammability
flame retardant acc. to IEC 60332-1-2 resp. VDE 0482-332-1-2
Tests
acc. to IEC 60811, EN 50395, EN 50396
General requirements
These cables are conform to the EU-Directive 2014/35/EU (Low Voltage Directive)