The User Spec of OPTIMA 2 BT Dongle
Revision History Rev. Date Author Reason for Changes 0.1 2009/4/16 Andy Lu Initial draft 0.2 2009/4/23 Andy Lu 0.3 2009/4/27 Andy Lu 0.4 2009/4/27 Andy Lu 0.4 2009/8/4 Frank Feng Add “page device time out” to the flowchart Modify “pairing” to “paging device list” 1. Change in button function “After press 7s or more, dongle will clear the device list. The dongle will enter into pairing mode automatically.” 2. Refer to "Page device" in the flow chart, please add "N<= 5min" beside "Fail".
1. Product Introduction OPTIMA 2 BT Dongle is a Plug and Play device for Windows 2000/XP/Vista and Mac OS. It is easy to install and use. OPTIMA 2 BT Dongle supports bluetooth profiles such asHFP, A2DP and AVRCP. 2. Product Exterior 1. LED Indicator (blue light) 2. Pairing Button 3. Introduction to LED Signals & button function 3.1 The LED light indicates different states with different blinking patterns.
. How to Use 4.1 Start the computer; 4.2 Put the Bluetooth headset (HS) into the pairing mode 4.3 Plug in the OPTIMA 2 BT dongle to the USB port of the computer • Windows: Wait for Window to automatically install the driver of OPTIMA 2 BT Dongle. A note will pop up from the taskbar indicating that the installation has been successful finished. • MAC OS: You may get a prompt saying “keyboard identifying process”. Close the dialogue and proceed to the next step. 4.
6. Button function Duration of pressing the pairing button can have different function as shows in the chart below: Press Duration State Functions Operation none idle Connected, playing paging Device list Short press 0.
Appendix Q&A 1. What's the power on (when just plug in USB port) status? Is it idle? What does dongle do in idle mode? => If the dongle remembered prepaired device, it will try to connect the prepaired device once power on. When in idle mode, the dongle will be connectable. It means if prepaired device is trying to connet the dongle at this time; the dongle is available for connecting. 2. What's the timeout of pairing? => The dongle is trying to pair any device which is in pairing mode.
FCC ID: ZG8USB06H IMPORTANT REGULATORY INFORMATION This device complies with Part 15 of the FCC Rules: Operation is subject to the following two conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference that is received, including any interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.