User's Manual

Thank you for purchasing our Bluetooth robot
sound box of BSK02B.
The Bluetooth robot sound box is a high
quality wireless audio device that provides
users the freedom to share music and calls
whenever you want. It functions as " wireless
Bluetooth speaker " when linked to Bluetooth
phones or Bluetooth PC.
Introduction
Operation:
1>Turn on: please dial the button to "on" and
then you can find the LED ring flashes BLUE,
also have the voice.
2>Turn off: please dial the button to "on" and
then you can find the LED ring flashes RED,
also have the voice.
3> Prepare your BSK02B for pairing: dial the
on switch in the upmost position and then
press the MFB buttons for about 6 seconds,
wait for the LED ring to flash red & blue,
that it is ready to pair.
4>Make the connection: Go to your device's
Bluetooth settings, when BSK02B appears
Robot bluetooth speakers
User manual
1.Speaker
2.USB
3.Volume up
4.Mic
5.Push down (play/pause music;
answer/end call)
6.Volume down
7.Led
8.ON/OFF
8>Volume controls: increase and decrease
volume using the Plus and minus buttons
on BSK02B
9> Redial last number : Press the MFB on the
standby status.
10> Voice activated dialing: It is possible to
make a call directly from the headset using
voice recognition. To use this voice dialing
function, your mobile phone must provide
this option and corresponding voice samples
must have been recorded.
Step-1 Enable voice recognition function of
your mobile and set the mobile to standby
state.
Step-2 When no call is in progress, press and
hold the MFB until you hear a beep sound
from the BSK02B.
11> Voice transfer: Press and hold MFB for
3 seconds on talking status until to hear a
stone sound and then transfer to phone.
If need to transfer to speaker, please use
the same way.
select it. Enter"0000".
5>Answer/End call: Press the MFB on your
BSK02 to both answer and end a call.
6> Reject an incoming call: press the MFB
for 2 seconds.
7>End a call: short press MFB once
12> Muting:mute the built-in microphone by
holding the plus and minus buttons until you
hear a beep.
13>Support A2DP but can't support AVRCP
( It means can support play music ,but
can't support the control up and down song,
play / pause function)
Bluetooth Specification v3 . 0 syetem
* Bluetooth Profile Supported: HSP V1.2,
HFP V1.5, A2DP V1.2 ,
* RF Frequency Range: 2 . 4 0 2‐2.480GHZ,
2.4G ISM band，
* Radio Performance: Receive Sensitivity of
‐90dBm, TX Power Max 4dBm，
*Class2 bluetooth device,operating range:
Up to 10M，
*Advanced multipoint support: enables
connection to 2 phones for voice
*Multipoint A2DP streaming: enables
connection to 2 A2DP source devices for
music playback，
*
®
Specifications:
AUDIO:
* Frequency Response: 20 Hz ‐ 20 KHz, Very high
1
2
3
6
4
5
7
8