Open-Q 865 SOM_Module_Certification_TechNote89_OEM _Integrator_Guide [Document: ICS-01RND1459-TN-089 Revision: 1.3] NOTICE TO PERSONS RECEIVING THIS DRAWING AND/OR TECHNICAL INFORMATION Lantronix. claims proprietary rights to the material disclosed hereon. This drawing and/or technical information is issued in confidence for engineering information only and may not be reproduced or used to manufacture anything shown or referred to hereon without direct written permission from Lantronix. to the user.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 Identification Document Title Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Document Number ICS-01RND1459-TN-089 Version 1.3 Date Mar 22, 2021 History REVISION DATE DESCRIPTION PAGES 0.0 Jan 13, 2021 Initial Draft All 0.1 Feb 4, 2021 Made correction to Applicable Module PMN 3 1.0 Mar 5, 2021 Replaced FCC and IC Declaration sections as per recommendations by the TCB. 8-14 1.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 Table of Contents 1. INTRODUCTION...................................................................................3 2. APPLICABLE MODULE .......................................................................3 3. ADDITIONAL REGULATORY CONFORMANCE TESTING AND/OR SUBMISSIONS REQUIRED BY THE INTEGRATOR .....................................3 4. COMPLIANT/ALLOWABLE TX POWER SETTINGS ..........................3 5.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 1. INTRODUCTION This document describes the steps that the OEM integrator must follow when designing and manufacturing a system utilizing the Open-Q 865 SOM Transmitter Module. Failing to follow the instructions in this document may invalidate the FCC and IC (Industry Canada) certifications and authorizations of the Module for use in the U.S. and Canada.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 5. ALLOWABLE ANTENNAS TO USE WITH THE RADIO MODULE The module is certified for use with certain antennas as described in this section. Allowed Antenna Types: 1. Dipole antenna Table 1 Allowed Maximum Gain (dBi) Dipole, Including Cable Loss 2.4~2.5GHz 3.32 4.9~5.8GHz 6.11 The required antenna impedance is 50 ohms.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 6. ANTENNA PLACEMENT AND RF SAFETY The FCC and other countries’ regulatory bodies impose strict conditions and limitations on the RF exposure levels of end products. Acceptable RF exposure levels for this Module depend on transmit power, the location of the transmitting antenna(s) inside the host system and the expected separation of the transmitting antennas to the end user.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 Because the rules are highly dependent on the characteristics of the particular radios that are co-located and simultaneously transmitting, the OEM integrator should seek guidance from a knowledgeable test lab or consultant to determine if additional testing and certification is required.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 Also see https://www.fcc.gov/logos. A certified modular has the option to use a permanently affixed label, or an electronic label (Refer to FCC KDB 784748 D02 e labeling for e-labelling guidance). All modules without an integrated display on the module must be labelled with a module’s FCC ID - Section 2.926. 9.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 10. REQUIRED LABELING ON THE MODULE 10.1 FCC and Industry Canada Labelling on the Module The OEM integrator must ensure that the FCC ID and IC number is affixed on the Module or in a User/Installation Manual along with other country certification numbers and logos as described herein. Note: the original Module manufacturer may affix regulatory labeling at time of Module manufacturing.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 2.6 RF exposure considerations This equipment complies with FCC mobile radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. If the module is installed in a portable host, a separate SAR evaluation is required to confirm compliance with relevant FCC portable RF exposure rules. 2.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 OEM/Host manufacturer responsibilities OEM/Host manufacturers are ultimately responsible for the compliance of the Host and Module. The final product must be reassessed against all the essential requirements of the FCC rule such as FCC Part 15 Subpart B before it can be placed on the US market. This includes reassessing the transmitter module for compliance with the Radio and EMF essential requirements of the FCC rules.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: (Pour utilisation de dispositif module) 1) L'antenne doit être installé et exploité avec plus de 21 cm entre l'antenne et les utilisateurs, et 2) Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 The end user manual shall include all required regulatory information/warning as shown in this manual. Manuel d'information à l'utilisateur final L'intégrateur OEM doit être conscient de ne pas fournir des informations à l'utilisateur final quant à la façon d'installer ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intègre ce module.
Open-Q 865 SOM_Module_Certification_TechNote89_OEM_Integrator_Guide Rev. 1.3 (iv) lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs), les numéros de modèle de l’antenne et les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de la p.i.r.e. applicable au masque d’élévation, énoncée à la section 6.2.2.3, doivent être clairement indiqués. 12.
