Quick Installation Guide 5-Port 10/100/1000 Mbps Green Switch Model# AGSW503 Ver.
Introduction This Quick Installation Guide tells you how to install your 5-Port 10/100/1000Mbps Green Switch, and how to connect it to your Gigabit Ethernet network. The 5-Port 10/100/1000Mbps Green Switch is designed for energy saving, easy installation and high performance in an environment where network traffic and the number of users increase continuously. You can add other Ethernet devices like computers, IP cameras, and Network Attached Storage (NAS) onto your network quickly and easily.
Hardware Description Front Panel LED Indicators LED Color POWER Green LNK/ACT Green Status Description On The switch is powered on. Off The switch is powered off. On LAN port is connected. Off LAN port is not connected. Flashing Transferring or receiving data. Rear Panel Item Name Description Power Power connector, DC 5V / 1.0A. 1-5 10/100/1000Mbps LAN ports 1 to 5.
Section 2 Connecting the Switch Note: Operating Environment This switch must be installed and operated within the limits of specified 0 operating temperature (32~131 F) and humidity (10~90% Non-condensing). Do not place objects on top of the unit. Do not obstruct any vents at the sides of the unit. Do not position the unit near any heating source such as heater, radiator, or direct exposure to sun. Prevent entering of water and moisture into the unit. If necessary, use dehumidifier to reduce humidity.
Section 3 Troubleshooting 1. Power LED is not lit Check if the power adapter is properly connected to the power outlet. Make sure the power jack is firmly plugged into the power socket of the switch. 2. Link/Activity is not lit when connect to 10/100/1000Mbps device Check the power switch of the network device attached to the switch; make sure it is turned ON. Check the network cable; make sure it is properly connected to the switch and the network device.
Section 4 FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by party responsible for compliance could void the user’s authority to operate the equipment.
Section 5 Technical Support E-mail: support@airlink101.com Website: www.airlink101.com *Power savings may vary depending on products used. Actual data throughput will vary. Network conditions and environmental factors lower actual data throughput rate. Specifications are subject to change without notice. All rights reserved. Copyright © 2011 AirLink101®.
