Landis+Gyr Gridstream RF Enhanced kV2c Endpoint Data Sheet Publication: 98-1083 Rev AA LANDIS+GYR CONFIDENTIAL INFORMATION
Limitation on Warranties and Liability Information in this document is subject to change without notice. This manual or any part of it thereof may not be reproduced in any form unless permitted by contract or by written permission of Landis+Gyr.
Landis+Gyr Gridstream RF Enhanced kV2c Endpoint Data Sheet Endpoint Overview Landis+Gyr Gridstream RF Enhanced kV2c Endpoint CONTAINS FCC ID: TEB-HUNTSG10122 CONTAINS IC: 5931A-HUNTGS10122 XXXXXXXX MODEL 40-6100 Figure 1. kV2c Endpoint This communication module is not available as a stand alone product. To order a Gridstream RF Enhanced kV2c Endpoint, the Landis+Gyr kit number is 45-6100 with ZigBee or 45-6101 without ZigBee.
Data Sheet Landis+Gyr FCC Compliance Information Model: 40-6100 (Forms 1S, 2S, 9S, 12S, 16S, 45S) FCC ID:TEB-HUNTGS10122 Module: 10122 Industry Canada Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.
Landis+Gyr Data Sheet RF Interference This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Data Sheet Landis+Gyr 1. LAN ID, includes programmed module part number (printed and barcoded) 2. Product ID (printed and barcoded) 3. FCC ID:TEB-HUNTGS10122 4. ICC ID: 5931A- HUNTGS10122 Features and Functions Using the GE High Speed kV2c Meter with the Gridstream RF kV2c Enhanced endpoint, you can: • Integrate the endpoint into all forms, classes and voltages of the GE kV2c meter. • Communicate via serial connection between the endpoint and the meter through the meter's provided interface.
Landis+Gyr Data Sheet • Meter configuration information Once this information has been sent the meter/endpoint starts collecting and sending based on the default configuration loaded during manufacturing. Retrieving Data The endpoint performs data retrieval from the meter on request (ORR) or autonomously (periodically reported). Availability of the following features depends on meter configuration.
Data Sheet Landis+Gyr • LAN ID • Outage time • Reboot count. The endpoint sends the message, then assists with routing other packets until the back-up energy source can no longer keep the radio alive. The time that this energy source is available varies with several factors, including amount of data packets being routed, environmental conditions and age of meter/endpoint. Generally, a hold-up time of ~45 seconds is typical.
Landis+Gyr Data Sheet Specifications Table 1.
Data Sheet Landis+Gyr RF ZigBee 10 Output Power +20 dBm +/-1 Adjacent Channel Power 40 dBc Minimum Transmit Frequency 2405-2480 MHz Communication Protocol ZigBee Protocol Receive Sensitivity -104 dBm minimum 98-1083 Rev AA Data Sheet
