Installation Guide

Table Of Contents

LEDGESTONE PLANTER INSTRUCTIONS

SCENARIO 1- SINGLE LAYER ON SOLID GROUND

SCENARIO 2- DOUBLE LAYER ON SOLID GROUND

STEP 1:

Choose (A) if you are installing your planter on solid ground (i.e. concrete) or soft ground (i.e. dirt)

and (B) if you are installing one or two layers. Continue to the appropriate scenario below.

A) Using SHORT fiberglass pins, connect panels in desired planter shape. Push pins down (pointed end first)

through each of the hinge holes until pin hits the ground. See Figure 1 and Figure 2. It might be necessary

to push the pin down using the flat end of another pin.

A) Using LONG fiberglass pin, connect panels in

desired planter shape. Push pins down (pointed end

first) through each of the hinge holes. See Figure 3.

B) Remove 2 pins and set 2 second layer panels at

those two joints, then re-insert the pins through each

of those hinge holes until pin hits the ground. See

Figure 4 and 5. It might be necessary to push the pin

down using the flat end of another pin. Continue two

panels at a time until the second layer is complete.

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

PAGE 1
LEDGESTONE PLANTER INSTRUCTIONS STEP 1: Choose (A) if you are installing your planter on solid ground (i.e. concrete) or soft ground (i.e. dirt) and (B) if you are installing one or two layers. Continue to the appropriate scenario below. SCENARIO 1- SINGLE LAYER ON SOLID GROUND A) Using SHORT fiberglass pins, connect panels in desired planter shape. Push pins down (pointed end first) through each of the hinge holes until pin hits the ground. See Figure 1 and Figure 2.
PAGE 2
SCENARIO 3 - SINGLE LAYER ON SOFT GROUND A) Using LONG fiberglass pins, connect panels in desired planter shape. Push pins down (pointed end first) through each of the hinge holes until pin hits the ground. See Figure 6. B) Hammer pins into the ground until the flat end is flush with the top of the panel. See Figure 7. Figure 6 Figure 7 SCENARIO 4 - DOUBLE LAYER ON SOFT GROUND A) Using LONG fiberglass pins, connect panels in desired planter shape.