ADG Installation Instructions Aversan Inc. Suite 500 30 Eglinton Avenue West Mississauga, ON L5R 3E7 Canada t: 416.289.1554 f: 416.289.1554 info@aversan.com www.aversan.com ©Aversan Inc. 2020. All rights reserved.
Aversan Inc. Table of Contents Overview ....................................................................................................................................................... 2 Accessories .................................................................................................................................................... 2 Operating Environment ................................................................................................................................
Aversan Inc. Overview The Aircraft Data Gateway 400 (ADG-400) acts as the gateway for all data that flows into and out of the avionics and/or cabin system. ADG-400 also provides mass storage functionality for storage of avionics bus data, maintenance data, databases, operational software and other data the avionics components may choose to store.
Figure 1: DZUS Mount Dimensions
Aversan Inc. Figure 2: Flange Dimensions Rev. 1.
Aversan Inc. Figure 3: Flange Rear View Suggested Fastener Specifications for Flange Mount to Aircraft: Type = #10-32 Specifications = NAS1351C3-6 or Equivalent * *length may be used based on the application Head diameter between .30 to 0.31 Inches Torque = 26 in-lb Suggested Washer Specifications for Flange Mount to Aircraft Type = Locking Specifications Met = MS35335-60 or NASM35335 Aircraft Mounting Surface Material Aluminum or Stainless Steel Rev. 1.
External WiFi and Cellular (Client Communication) The ADG-400 uses the External WiFi or Cellular modules to establish connection to ground based servers based on network priority defined in the configuration file. Both the Client Wi-Fi and Cellular modems are disabled in air and are operational only on ground. The External WiFi and Cellular RF signals use the same antenna connections on the rear of the ADG-400 through a software controlled RF switch.
Aversan Inc. RF Access Internal Antennas (Front Panel) The internal antennas are located on the front panel to either side of the access door. Figure 4: Front Panel Antennas Location The front panel antennas used are Laird FlexPIFA U.FL Antennas. A custom Laird part number was required due to the length of the antenna cable (250mm) required to reach the PCB. The custom part number EFB2455A3S-25MHF1 originated from the COTS FlexPIFA 001-0016.
Aversan Inc. Configurations and External Interfaces The ADG-400 consists of a core unit and can include two replaceable module interfaces (RMIs). Core Unit The core unit contains front and rear facing interfaces. All interfaces listed below are rear attached to the rear panel except for those explicitly called out.
Aversan Inc.