User Manual

ManualsBrandsLaipac Technology ManualsElectronicsRemote Controlled Internet Switch

NETGUARD

Netguard User Manual

Introduction

The Netguard is used to control the access to Internet. This manual shows how to setup

and operate the Netguard.

Package

1. One Netguard cable with attached Relay box and Receiver box.

2. One AC120V-DC5V adapter.

3. One Remote Controller.

Laipac Technology, Inc. | www.laipac.com | Tel: 1-(905)762-1228 Fax: 1-(905)763-1737 1

Summary of content (4 pages)

PAGE 1
NETGUARD Netguard User Manual Introduction The Netguard is used to control the access to Internet. This manual shows how to setup and operate the Netguard. Package 1. One Netguard cable with attached Relay box and Receiver box. 2. One AC120V-DC5V adapter. 3. One Remote Controller. Laipac Technology, Inc. | www.laipac.
PAGE 2
NETGUARD Block Diagram RJ45 Ethernet Cable RJ45 Relay Box Control Line Receiver Box DC 5V Adapter Remote Controller Block Description Relay Box The solid relays inside the Relay Box control the connections of RJ45 cable. Solid relays are controlled by Receiver Box through control line. Receiver Box The receiver circuit inside Receiver Box decodes the RF signal transmitted by Remote Controller and send out corresponding command through control line to control solid relays.
PAGE 3
NETGUARD Setup 1. Encoding and Decoding switch setup (optional) There is one pair of 8-position switches for netguard encoding and decoding. One is inside the remote controller; the other is inside the receiver. The two switches can be set to be in any positions, but the position settings of them must be the same. 2. Antenna setup There is an antenna (a piece of green wire) inside the receiver. It is convenient to pull it out through the hole on the side of the receiver case.
PAGE 4
NETGUARD Operation 1. Connect the Netguard cable with the target computer and router (or other Ethernet outlet). 2. Connect DC5V adapter to Netguard receiver. The power LED should be on. 3. Press the OFF(stands for block off) button of the remote controller, the status LED on the receiver turns on, indicating that it is ready to access Internet. 4. Press the ON (stands for block on) button of the remote controller, the status LED on the receiver turns off, indicating that access Internet is blocked.