Installation & Assembly

INSTALLATION INSTRUCTIONS
ASME A112.18.1 / CSA B125.1
1. Before Proceeding
We recommend calling a professional if you are
uncertain about installing this product! This product
should be installed in accordance with all local and
state plumbing and building code requirements.
2. Shut Off Water Supplies
Locate the water supply inlets and shut off both the
hot and cold water supply valves. If you are
replacing an existing faucet, remove the old faucet.
Clean the sink surface thoroughly in preparation for
the new faucet.
3. Mount the Faucet
Position the faucet on the sink. If the sink surface is
uneven, a small amount of silicone sealant may be
needed. Make sure to insert the rubber washer in-
between the faucet and the sink.
 Model 2010
 Concord Series
 1 Hole Installation
You may need:
For easy installation of your faucet
please:
 READ ALL the instructions,
warnings, care and maintenance
information before beginning
 Purchase the correct water supply
hook-up
4. Secure the Faucet
From underneath the sink, attach the rubber and metal
washer through the shank, and tighten the locknut until
the faucet is securely in place.
5. Connect to Water Supplies. Flush System/Check for Leaks
Connect the water supply lines directly to the supply stops.
Remove the aerator. Turn the handle all the way on. Turn
on hot and cold water supplies and flush water lines for
one minute. This flushes away any debris that could cause
damage to internal parts. Check all connections for leaks.
Replace aerator. Re-tighten if necessary, but do not over
tighten.