Installation Instructions

1
2
Batteria CR 2450
Circa 3 anni
Rolling code
433.92 MHz ISM
Alimentazione
Durata batteria
Frequenza radio
Portata
Battery CR 2450
About 3 years
Rolling code
433.92 MHz ISM
15 m (inside buildings)
Power supply
Battery life
Code
Radio frequency
Range
+
DATI TECNICI
CAMBIO BATTERIA
BATTERY CHANGE
TECHNICAL DATA
1 DESCRIZIONE
Radiocomando rolling code 433.92 MHz
SMART 1 MONO: 1 canale, funzioni dimmer
SMART 1 EDC: 1 canale, funzioni EDC
SMART 1 RGB: 1 canale, funzioni RGB
2 PROGRAMMAZIONE DEL TRASMETTITORE
Con questa procedura si programma un trasmettitore per associarlo a una ricevente compatibile.
Per eseguire la seguente procedura è necessario accedere alla ricevente.
PROCEDURA:
1- Attivare la ricevente sulla quale si vuole utilizzare il trasmettitore (vedi il manuale della ricevente)
2- Inviare un comando agendo sull’area touch del dispositivo, il led della ricevente emette tre lampeggi per
segnalare l’avvenuta ricezione.
3- Il trasmettitore torna allo stato di stand by.
1 PRODUCT FEATURES
Remote control rolling code 433.92 MHz
SMART 1 MONO: 1 channel, dimmer function
SMART 1 EDC: 1 channel, EDC function
SMART 1 RGB: 1 channel, RGB function
2 TRANSMITTER PROGRAMMING
This procedure is used to programme a transmitter in order to then associate it with a compatible receiver.
Access to the receiver is required to carry out the following procedure.
PROCEDURE:
1- Activate the receiver on which you want to use the transmitter (see receiver manual).
2
3- The transmitter goes back into stand-by.
Type: CR2450
031-FIS17A_Smart_1_MONO_EDC_RGB
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC NOTE： This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY
CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR
COMPLIANCE. SUCH MODIFICATIONS COULD VOID
THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
The device has been evaluated to meet general RF
exposure environment.