Quick Start Guide

IMW1300
In the Box
A Closer Look
Charging
QUICK START GUIDE
Wireless Speaker
Powering On/
Bluetooth
Pairing
Light Change
Mode
USB-C Charging Cable
True Wireless
Pairing
-
+
-
+
Volume Up
Volume Down
Play/Pause
Answer & End Call
Speaker
Controls
PRESS
ON/OFF
Next Track
Previous Track
Reject Incoming Call
PRESS & HOLD (2 sec)
1-2 SEC
PRESS & HOLD
Turn on the first speaker and connect It
with a Bluetooth compatible device.
(red) = Charging
Complete
(off
) = Charging
Press
To activate Voice Assistant
(Siri or Google Assistant)
Disconnect Bluetooth: Press
and hold for five seconds and
the speaker will beep
Reset All connections: Press
and hold for ten seconds and
the speaker will power off
Reset- Press & Hold
Press
1-2 SEC
PRESS & HOLD
Overall battery performance varies dependent upon
use setting, and environmental conditions. For
further information, please visit
www.alteclansing.com
Reset
USB Port
Power Button
Link Button
Color Change Button
USB-C Charging
Port
Volume Down/Previous Track
Volume Up/Next Track
≈3-4 Hours
Full Charge
connected
AL HydraBlast
Paired
Solid Blue
Flashing Blue
Second Speaker
Pairing Mode
To toggle between the different light modes:
1. Multicolor slow transition
2. Single color pulse to music
3. Multi color pulse to music
4. Single color slow fade
5. Single color
6. Multicolor cycle changed
7. Multicolor fast changed
with background color
8. Multicolor slow fade
9. Four color slow fade
10. Four color rotation
with pulse to music
11. Four color rotation
12. Off
Carabiner
IMW1300 HydraBlast Everythingproof
Wireless Speaker
TM
HydraBlast Everythingproof
TM
Flashing Green = Pairing
Press & Hold the button for 1-2 sec to
change the Strobe light modes.
* off Pulse to music Blink off *
Solid Green = Paired
Turn on the second speaker and press the
button on that speaker.
Press and hold the button for 2-3
seconds on the first speaker. The first
speaker will now connect to the second
so they both play in sync. The Link Buttons
will illuminate green.
To end TWS press & hold the power button
on the speaker.
There are two modes:
Mode 1: Dual Stereo, both play stereo for parties etc.
Mode 2: Wide Stereo, one plays left and the other right.
Briefly press the button to switch between the
modes.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Sakar International Inc.
195 Carter Drive
Edison, New Jersey 08817, USA
855-292-4087
www.alteclansing.com
Voice Assistant /
Reset