User's Manual
English
1. General Functions
2. Pairing to a phone or entertainment device:
TurnonyourphoneandensureitsBluetoothfunctionis
activated.
TurnontheBluetoothHeadsetandgototheparingmode.
SearchyourBluetoothdevicesonyourphonebyfollowingthe
phone'sinstructions.Refertoyourphone'susermanualfor
moreinformation.
Afterafewsecondthephonewilllistthedeviceasadiscover
device.
Selectitandfollowyourphoneinstructiontoselectthis
pairing.
Yourphonewillconfirmthepairing,andthenpressYes/Ok
Finally,select“connectwithdevice”fromyourphone.
3. Line in input
HS‐930BTsupportsa3.5mmaudiojacklineinwhenthebatteryis
loworwherewirelessdevicescannotbeused.
FCC Caution: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2)this device must accept any interference
received, including interference that may cause
undesired operation.
This device and its antenna(s) must not be co-located
or operating in conjunction with any other antenna or
transmitter.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and
receiver.
--Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV
technician for help.
Declaration of Conformity(R&TTE 1999/5/EC)
Hereby, KYE SYSTEMS CORP.,Ltd declares that this
Bluetooth Speaker product is in compliance with
essential requirements and other relevant provisions
of Directive 1999/5/EC.A copy of the Declaration of
conformity can be found at http://www.geniusnet.com
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set
forth for an uncontrolled environment. This device was tested for
typical hand held operations with the device contacted directly to the
human body to the sides of the device. To maintain compliance with
FCC RF exposure compliance requirements, avoid direct contact to the
transmitting antenna during transmitting
Turnon
Presspowerbuttonuntilthelightturnsblue,ifthereis
adeviceconnectedbefore,automaticallyconnectthe
previousdevice,otherwiseenterpairingmode,the red
andblueflashinturns.
Enterthe
pairing
mode
Ifproductispairedbefore,itwillautomaticallyconnect
thepreviousdevicewhenturnedon.Ifthere’sno
previousdevice,itwillenterpairingmode,theredand
blueflashinturns,whenconnected,andtheblueLED
flashesbluetwiceper5seconds.
Pairing
Inpairingmode,useamobilephonewithBluetooth
functionorotherBluetoothMasterDevicetoperform
pairingaction.
Turnoff
Whendeviceison,pressthepowerbutton4seconds,
theredLEDflashesfor1second,theproductshuts
down.
Charging Plugthechargertoportofthedevice.(RedLEDison.)
Answercall Shortpresspowerbuttonforanincomingcall.
Endcall Shortpresspowerbuttonagaintoendcall.
Transfercall
between
headsetand
device
Longpresspowerbuttonfor1secondtotransferthe
callbetweenthemobilephoneandthedeviceduring
on‐goingcall.
Rejectcall
Longpresspowerbuttonfor1~2secondstoreject
incomingcall.
Incoming
secondcall
Whenthere’sasecondincomingcall,shortpressthe
powerbuttontoanswerthesecondcallorlongpress
thepowerbuttonfor1secondtorejectthesecondcall.
Whenansweringthesecondcall,thecurrentcallwillbe
onhold.Longpressthemiddlebuttonfor1secondto
switchbetweenthesecondcallandthepreviouscall,
shortpressthemiddlebuttontoendthecurrentcall.
Volumeup ShortPress“+”buttonforvolumeup.
Volume
Down
ShortPress“‐”buttonforvolumedown
Next Shortpress“V”buttonfornexttrack.
Previous
Shortpress“Λ”buttonforprevioustrack.
Play/pause
Shortpresspowerbuttontoplay/pausethemusic
whentheproductisconnected.
Standby
Underpairingmode,ifthereisnodevicetoconnect,it
goesintostandbymode.
Automatic
power‐off
Instandbymode,ifthereisnodevicetoconnect,itwill
shutdownautomaticallyin2minutes.
Factory
reset
Press“+”and“‐”for4seconds,lightflashesredonce,
torestorefactorysettings.Pairinginformationis
cleared,youwillneedtoenterpairingmodeagainto
activatetheBluetoothfeature.