User Manual

ManualsBrandsKYE Systems ManualsAudio EquipmentBluetooth Speaker

ENGLISH

User Manual

LED Status

Power On Blue LED On

Pairing Blue LED blinks quickly

Paired Blue LED blinks slowly

AUX IN, BT standby Blue LED On

Power Off Red LED blinks and turns off

Charging Red LED On, then turns off when fully-charged

Battery Low Red LED blinks slowly (see battery recharging)

Pair a Bluetooth Device:

To play audio from a Bluetooth device, you need to turn on your

Bluetooth device and pair it with the SP-960BT.

1. Turn on the SP-960BT and then press and hold the button

and the blue LED will flash slowly. When it starts to flash quickly,

this means it is entering pairing mode.

2. When you activate your device's Bluetooth function, it will begin

to scan for the device. When “Genius SP-960BT” appears on the

Bluetooth device list, select the SP-960BT. The Bluetooth status

light will blink slowly after pairing is established.

Note 1: Most devices do not require you to key in the pin code. In

case you have to, key in “0000”.

Summary of content (4 pages)

PAGE 1
ENGLISH User Manual LED Status Power On Blue LED On Pairing Blue LED blinks quickly Paired Blue LED blinks slowly AUX IN, BT standby Blue LED On Power Off Red LED blinks and turns off Charging Red LED On, then turns off when fully-charged Battery Low Red LED blinks slowly (see battery recharging) Pair a Bluetooth Device: To play audio from a Bluetooth device, you need to turn on your Bluetooth device and pair it with the SP-960BT. 1.
PAGE 2
ENGLISH Note 2: After pairing successfully once, to reconnect the speaker, just button. Then wait turn on the speaker and press and hold the for the intermittent blue light to blink and release. If the speaker does not connect, go back and repeat Steps 1 and 2. Play Music: 1. After Bluetooth pairing is successful, turn on the music player software on your cell phone or other Bluetooth device and you are ready to play. 2. Use the 3.5mm to 3.5mm cable to connect the unit to another audio source.
PAGE 3
ENGLISH Charge the Battery: If the lithium battery is low and requires charging, just attach the USB cable to the speaker and your PC/notebook. Warning: Avoid exposing the speakers to rain, moisture, or any other liquids and make sure no object filled with liquids, such as vases, etc., are placed near them. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 4
ENGLISH This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.