Integration Instructions

FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 cm between the
radiator and a human body.
If the identification number is not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to the
enclosed module, Contains FCC ID: 2AM4E37130AGJ5.
Co-location of this module with other transmitters that operate simultaneously are required to be
evaluated using the multi-transmitter procedures.
The host integrator must follow the integration instructions provided in this document and ensure that
the composite-system end product complies with the requirements by a technical assessment or
evaluation to the rules and to KDB Publication 996369.
The host integrator installing this module into their product must ensure that the final composite
product complies with the requirements by a technical assessment or evaluation to the rules, including
the transmitter operation and should refer to guidance in KDB 996369.
This module will be installed into a motorcycle instrument panel and only approved for use by the
grantee in its own products. It not intended for sale to third parties,thus the integration instructions not
be detailed. The instructions placed in the theory – of –operation exhibits using for long term
confidential.