User's Manual

006-0799-00 Rev 1

Digital Wireless

Audio DSS

Operating

Instructions

The Digital Wireless Audio DSS system is a digital frequency-agile radio designed to achieve

excellent audio recording for the various Eyewitness Video systems.

Transceiver Setup

The Digital Wireless Audio DSS transceiver can be worn on a duty belt using the supplied

pouch, or without the pouch, it can be worn/attached to an epaulet using the integrated clip. The

epaulet clip remains on the transceiver even if the pouch is used – it will fit easily within the

pouch.

Base Station Setup

The base station should be mounted according to the installation instructions (007-0798-00)

found in the base station installation kit. You will need to attach the two antennas, then mount

and connect the cable. For best reception, the antennas should be perpendicular to the ground.

Operation

Place the Transceiver (Mic) unit in the Base Unit (Base). This will “sync” the two devices. This

sync will remain until the Mic is placed in a different Base or until a new Mic is placed in the

Base. The last synchronization performed will override all earlier syncs. Under normal

conditions, leaving the Mic in the Base will also charge the Mic, but there is no other need to

place the Mic into the Base.

After “syncing” is complete, the operation is very simple.

The transceiver can be used with or without the

supplied mic cord. There is an internal mic on the

transceiver that will be used if you do not use the cord,

or if the cord becomes damaged. For best results, we

recommend you use the cord. When you plug it in,

route the cord downward as shown, so the strap will

hold the plug securely in place.

PAGE 1
006-0799-00 Rev 1 Digital Wireless Audio DSS Operating Instructions The Digital Wireless Audio DSS system is a digital frequency-agile radio designed to achieve excellent audio recording for the various Eyewitness Video systems. Transceiver Setup The Digital Wireless Audio DSS transceiver can be worn on a duty belt using the supplied pouch, or without the pouch, it can be worn/attached to an epaulet using the integrated clip.
PAGE 2
The Mic has a blue slide switch that is used to either 1) activate the audio system and start the video recording, or 2) to mute the audio while in the record mode. When audio is activated, you will feel a short “buzz” from the internal vibrator motor, and the LED’s will change to indicate the active mode (see LED legend below). To mute the audio, slide the switch again – this will result in two short buzzes from the internal vibrator.
PAGE 3
Kustom Signals Inc. FCC ID: IVQCCRMT Model No. CCDSS-REM Tested To Comply with FCC Standards This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Kustom Signals Inc. FCC ID: IVQCCBAS Model No.